IEC 62286-2003 PDF

IEC 62286-2003 PDF

Service diagnostic interface for consumer electronics products and networks Implementation for IEEE 1394

$72.51 $145.02 -50%
Product Code: IEC 62286
Stock In Stock
Edition: 1.0
Published: 05/2003
Number of Pages: 26
File Size: 1 file, 435 Bytes

Available Options

Product Description

Service diagnostic interface for consumer electronics products and networks Implementation for IEEE 1394

Introduction: Consumer products are often repaired by service workshops who are servicing all kinds of products developed by different manufacturers. For high complexity products, the fault diagnosis becomes more and more difficult and time consuming. To make diagnosis possible, manufacturers often develop some built-in diagnostic software which can be used for fault finding together with an external diagnostic unit through a Service Diagnostic Interface (SDI). To avoid the need for a service workshop to purchase several different diagnostic units from different manufacturers for different products, a standardized SDI is proposed for use by all manufacturers and in all products in which such diagnostic interfaces are required. The result will be that only one SDI is needed in the service workshops. The SDI should also be suitable for diagnosis in a network (A/V or multimedia network) in which different products from different manufacturers are connected together. The interface should also allow for future development. The standard SDI which has to be specified, should: be usable in future products; be easily connectable to a product or a network; be cheap; not limit product design.

Scope: This International Standard specifies the requirements that have to be implemented in future products that incorporate a digital interface, and service diagnostic software developed for these products. The Service Diagnostic Interface (SDI) requires the use of a PC (desktop or laptop) into which service diagnostic software can be loaded. A part of this PC software has to be standardised while another part of this PC software is manufacturer/product related. To reach a common approach in servicing all products from all manufacturers, it is necessary to standardise specific items in the products (Device Under Test/DUT) as well as in the diagnostic software on the PC. The Service Diagnostic Interface (SDI) is based on the IEEE 1394:1995 specification because this interface will be used in most future products. The use of this connection and existing communication protocols enable implementation in products at low cost, and gives maximum flexibility and efficiency. The SDI consists of: Specific hardware and software requirements of the DUT. Specific requirements of the PC: the Service software, an IEEE 1394 interface (to be built in if not already present). The connection between the PC and the DUT. This specification is a minimal specification necessary to be able to carry out computerised diagnosis and covers the standardised software of the PC as well as the standardised software and provisions in the DUT. If an IEEE 1394 interface is present on the product, then the requirement for product identification as described in this document (see 6.3) is mandatory. In addition, all communication for any service application should go through the IEEE 1394 interface only, as described in this document (in Clause 7).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62286-2003 PDF

IEC 62286-2003 PDF

$72.51 $145.02