Protection against lightning – Part 4: Electrical and electronic systems within structures
Introduction: Lightning as a source of harm is a very high energy phenomenon. Lightning flashes release many hundreds of mega-joules of energy. When compared with the milli-joules of energy that can be enough to cause damage to sensitive electronic equipment in electrical and electronic systems within a structure, additional protection measures will be necessary to protect some of this equipment. The need for this International Standard has arisen due to the increasing cost of failures of electrical and electronic systems, caused by electromagnetic effects of lightning. Of importance are electronic systems used in data processing and storage as well as process control and safety for plants of considerable capital cost, size and complexity (for which plant outages are very undesirable for cost and safety reasons). Lightning can cause different types of damage in a structure, as defined in IEC 62305-1. IEC 62305-3 deals with the protection measures to reduce the risk of physical damage and life hazard but does not cover the protection of electrical and electronic systems. This part of IEC 62305 therefore provides information on protection measures to reduce the risk of permanent failures of electrical and electronic systems within structures. Permanent failure of electrical and electronic systems can be caused by the lightning electromagnetic impulse (LEMP) via: conducted and induced surges transmitted to equipment via connecting wiring; the effects of radiated electromagnetic fields directl
Scope: This part of IEC 62305 provides requirements for the design, installation, inspection, maintenance, and testing of surge protection measures (SPM) for electrical and electronic systems to reduce the risk of permanent failures due to lightning electromagnetic impulse (LEMP) within a structure. This document does not cover protection against electromagnetic interference due to lightning, which can cause malfunctioning of internal systems. However, the information reported in Annex A can also be used to evaluate such disturbances. Protection measures against electromagnetic interference are covered in IEC 60364-4-44 [3] and in the IEC 61000 series [4]. This document provides guidelines for cooperation between the designer of the electrical and electronic system and the designer of the protection measures, in order to achieve optimum protection effectiveness. This document does not deal with detailed design of the electrical and electronic systems themselves.
Contents:
- FOREWORD
- INTRODUCTION
- Scope