IEC 62321-13 FRENCH-2026 PDF

IEC 62321-13 FRENCH-2026 PDF

Determination of certain substances in electrotechnical products - Part 13: Bisphenol A in plastics by liquid chromatography-diode array detector (LC-DAD), liquid chromatography-mass spectrometry (LC-MS) and liquid chromatography-tandem mass spectrometry (LC-MS/MS)

$132.41 $264.81 -50%
Product Code: IEC 62321-13 FRENCH
Stock In Stock
Edition: 1.0
Published: 06/2026
Number of Pages: 34
File Size: 1 file, 640 KB

Available Options

Product Description

Determination of certain substances in electrotechnical products - Part 13: Bisphenol A in plastics by liquid chromatography-diode array detector (LC-DAD), liquid chromatography-mass spectrometry (LC-MS) and liquid chromatography-tandem mass spectrometry (LC-MS/MS)

Introduction: The widespread use of electrotechnical products has drawn increased attention to their impact on the environment. In many countries this has resulted in the adaptation of regulations affecting waste, substances and energy use of electrotechnical products. The use of certain substances (e.g. lead (Pb), cadmium (Cd), mercury (Hg) and polybrominated diphenyl ethers (PBDEs)) and phthalates in electronical products is a source of concern in current and proposed regional legislation. The purpose of the IEC 62321 series is therefore to provide test methods that will allow the electrotechnical industry to determine the levels of certain substances of concern in electrotechnical products on a consistent global basis. This first edition of IEC 62321-13 introduces a new subject covering Bisphenol A in the IEC 62321 series.

Scope: This document specifies three techniques for the determination of free Bisphenol A (BPA) in plastics of electrotechnical products. This document describes the use of liquid chromatography–diode array detector (LC-DAD), liquid chromatography mass spectrometry (LC-MS), liquid chromatography tandem mass spectrometry (LC-MS/MS) with these test methods detailed in Annex A and Annex B. These test methods have been evaluated for use with PC, PC/ABS, PP matrices containing free BPA between 20 mg/kg to 500 mg/kg as shown in the Pre-IIS 13 results in Annex C and IIS 13 results in Annex D [1], [2]. The use of these methods for BPA concentration ranges of plastics, other than those specified in Annex C and Annex D, has not been evaluated. This document is a basic environment horizontal publication focusing on test methods and is primarily intended for use by committees in the preparation of publications within the area of environment in accordance with the principles laid down in IEC Guide 123. Wherever applicable, it is the responsibility of committees to make use of environment basic publications in the preparation of their environment group and product publications. Committees can apply this document directly to products when they do not develop a product publication in the area of environment. WARNING – Persons using this document should be familiar with normal laboratory practice. This document does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user to establish appropriate safety and health practices and to ensure compliance with any national regulatory conditions.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62321-13 FRENCH-2026 PDF

IEC 62321-13 FRENCH-2026 PDF

$132.41 $264.81