Digital addressable lighting interface – Part 203: Particular requirements for control gear – Discharge lamps (excluding fluorescent lamps) (device type 2)
Introduction: This first edition of IEC 62386-203 is published in conjunction with IEC 62386-101 and IEC 62386-102. The division of IEC 62386 into separately published parts provides for ease of future amendments and revisions. Additional requirements will be added as and when a need for them is recognised. This International Standard, and the other parts that make up the IEC 62386-200 series, in referring to any of the clauses of IEC 62386-101 or IEC 62386-102, specify the extent to which such a clause is applicable and the order in which the tests are to be performed. The parts also include additional requirements, as necessary. All parts which make up the IEC 62386-200 series are self-contained and therefore do not include references to each other. Where the requirements of any of the clauses of IEC 62386-101 or IEC 62386-102 are referred to in this International Standard by the sentence "The requirements of IEC 62386- 1XX, clause ’n’ apply”, this sentence is to be interpreted as meaning that all requirements of the clause in question of Part 101 or Part 102 apply, except any which are clearly inapplicable to the specific type of lamp control gear covered by Part 203. All numbers used in this International Standard are decimal numbers unless otherwise noted. Hexadecimal numbers are given in the format 0xVV, where VV is the value. Binary numbers are given in the format XXXXXXXXb or in the format XXXX XXXX, where X is 0 or 1; 'x' in binary numbers means 'don't care'.
Scope: This International Standard specifies a protocol and test procedures for the control of electronic control gear by digital signals used on a.c. or d.c. supplies, associated with discharge lamps (excluding fluorescent lamps). NOTE Tests in this standard are type tests. Requirements for testing individual control gear during production are not included.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Declaration of variables
- 11 Definition of commands
- 12 Test procedures