IEC 62417-2010 PDF

IEC 62417-2010 PDF

Semiconductor devices-Mobile ion tests for metal-oxide semiconductor field effect transistors (MOSFETs)

$15.77 $31.53 -50%
Product Code: IEC 62417
Stock In Stock
Edition: 1.0
Published: 04/2010
Number of Pages: 20
File Size: 1 file, 882 Bytes

Available Options

Product Description

Semiconductor devices – Mobile ion tests for metal-oxide semiconductor field effect transistors (MOSFETs)

Scope: This present standard provides a wafer level test procedure to determine the amount of positive mobile charge in oxide layers in metal-oxide semiconductor field effect transistors. . It is applicable to both active and parasitic field effect transistors. The mobile charge can cause degradation of microelectronic devices, e.g. by shifting the threshold voltage of MOSFETs or by inversion of the base in bipolar transistors. Abbreviations and letter symbols This standard uses the following abbreviations and letter symbols: CV test capacitance-voltage measurement HFCV test high frequency capacitance-voltage measurement Vg gate voltage tox oxide thickness Ids drain-source current positive power supply voltage Vdd,max maximum supply voltage Vt transistor threshold voltage Vt,initial the absolute value of the threshold voltage before the test Vsupply the absolute value of the supply voltage εox dielectric constant of the oxide General description The stress applied is on test structures at an elevated temperature where mobile ions can overcome the energy barriers at the interfaces and the ion mobility in the oxide is sufficiently high. Two test methods are described in this document. Bias temperature stress (BTS) Voltage sweep (VS). The bias temperature stress test is done on transistors. The threshold voltage is determined from an Ids - Vgs measurement at room temperature on fresh structures. The threshold voltage is defined as the gate voltage needed to force a fixed drain current through the transistor. Then, a positive gate stress is applied at a high temperature, to sweep the mobile ions towards the substrate. After the stress the test structure is cooled to room temperature with the bias still applied. A second Ids - Vgs curve is measured at room temperature. The sequence is completed with a negative gate stress at high temperature followed by an Ids - Vgs measurement at room temperature. Mobile charge causes a shift in the Ids - Vgs curve. The distance over which the curve is shifted is a measure of the amount of mobile charge in the insulator. – 10 – 62417 © CEI:2010 AVANT-PROPOS....................................................................................

Contents:

  • FOREWORD
  • Scope
  • 10 Reporting

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62417-2010 PDF

IEC 62417-2010 PDF

$15.77 $31.53