IEC 62458-2010 PDF

IEC 62458-2010 PDF

Sound system equipment-Electroacoustical transducers-Measurement of large signal parameters

$100.88 $201.76 -50%
Product Code: IEC 62458
Stock In Stock
Edition: 1.0
Published: 01/2010
Number of Pages: 28
File Size: 1 file, 1 Byte

Available Options

Product Description

Sound system equipment – Electroacoustical transducers – Measurement of large signal parameters

Introduction: Electro-mechanical-acoustical transducers such as loudspeaker drive units, loudspeaker systems, headphones, micro-speakers, shakers, and other actuators behave in a nonlinear manner at higher amplitudes. This limits the acoustical output and generates nonlinear signal distortion. Linear models fail in describing the large signal behaviour of such transducers and extended models have been developed which consider dominant nonlinearities in the motor and suspension. The free parameters of the large signal model have to be measured on the particular transducer by using static or dynamic methods. The large signal parameters show the physical cause of the signal distortion directly and are very important for the objective assessment of sound quality and failure diagnostics in development and manufacturing. Furthermore, the model and parameters identified for a particular transducer are the basis for predicting the maximum output and signal distortion for any input signal. The close relationship between causes and symptoms simplifies the interpretation of the harmonic and intermodulation distortion measured according to IEC 60268-5. Large signal parameters are valuable input data for the synthesis of loudspeaker systems and the development of electrical control systems dedicated to loudspeakers.

Scope: This International Standard applies to transducers such as loudspeaker drive units, loudspeaker systems, headphones, micro-speakers, shakers and other actuators using either an electro-dynamical or electro-magnetic motor coupled with a mechanical suspension. The large signal behaviour of the transducer is modelled by a lumped parameter model considering dominant nonlinearities such as force factor, stiffness and inductance as shown in Figure 1. The standard defines the basic terms and parameters of the model, the methods of measurements and the way the results should be reported.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Methods of measurement
  • 10.1 General
  • 10.2 Static or quasi-static method
  • 10.3 Point-by-point dynamic method
  • 10.4 Full dynamic method
  • 11 Nonlinear force factor
  • 11.1 Force factor curve Bl(x)
  • 11.2 Force-factor limited displacement, XBl
  • 11.3 Symmetry point, xsym(xac)
  • 11.4 Voice coil offset, xoffset
  • 12 Nonlinear stiffness
  • 12.1 Nonlinear stiffness curve Kms(x)
  • 12.2 Compliance-limited displacement xC
  • 12.3 Stiffness asymmetry AK(xpeak)
  • 13 Displacement-dependent inductance, Le(x)
  • 13.1 Inductance curve Le(x)
  • 13.2 Inductance-limited displacement, xL
  • 14 Current -dependent inductance, Le(i)
  • 14.1 Characteristic to be specified
  • 14.2 Method of measurement
  • 15 Parameters derived from geometry and performance
  • 15.1 Maximal peak displacement, xMAXd
  • 15.2 Method of measurement

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62458-2010 PDF

IEC 62458-2010 PDF

$100.88 $201.76