Nuclear power plants – Instrumentation and control important to safety – Management of ageing of electrical cabling systems
Introduction: a) Technical background, main issues and organisation of the Standard With the majority of nuclear power plants over 20 years old, the management of ageing of instrumentation and associated electrical cabling systems is currently a relevant topic, especially for those plants that have extended their operating licenses or are considering this option. This International Standard is intended to be used by operators of nuclear power plants (utilities), systems evaluators, and by licensors. b) Situation of the current Standard in the structure of the IEC SC 45A standard series IEC 62465 is the third level IEC SC 45A document tackling the specific issue of management of ageing of electrical cabling systems in nuclear power plants for Instrumentation and Control (I&C) systems important to safety. IEC 62342 is the second level chapeau standard of SC 45A covering the domain of the management of ageing of nuclear instrumentation systems used in nuclear power plants to perform functions important to safety. IEC 62342 is the introduction to a series of standards to be developed by IEC SC 45A covering the management of ageing of specific I&C systems or components such as electrical cabling systems (IEC 62465), sensors, and transmitters. IEC 62465 is to be read in association with IEC 62342 and IEC 62096, which is the appropriate IEC SC 45A Technical Report that provides guidance on the decision for modernization when management of ageing techniques are no longer successful. For more detai
Scope: This International Standard provides strategies, technical requirements, and recommended practices for the management of normal ageing of cabling systems that are important to safety in nuclear power plants. The main requirements are presented in the body of this International Standard followed by a number of informative annexes with examples of cable testing techniques, procedures, and equipment that are available for the nuclear industry to use to ensure that ageing degradation will not impact plant safety. This International Standard covers cables and their accessories (e.g., connectors) installed in nuclear power plants (inside and outside the containment). It provides requirements to perform cable testing for the purposes of predictive maintenance, troubleshooting, ageing management, and assurance of plant safety. It is concerned with Instrumentation and Control (I&C) cables, signal cables, and power cables of voltages less than 1 kV. More specifically, this International Standard focuses on in-situ testing techniques that have been established for determining problems in cable conductors (i.e., copper wire) and, to a lesser extent, on insulation material (i.e., polymer). It follows the IEC 62342 standard on “Management of Ageing” that was prepared to provide general guidelines for management of ageing of I&C components in nuclear power plants, including cables. It should be pointed out that cable testing technologies are evolving and new methods are becoming available that are not covered in this International Standard. More specifically, this International Standard covers typical cable testing methods that have been in use in the nuclear power industry over the last decade. It should also be pointed out that a single cable testing technique is unlikely to provide conclusive results, and a reliable diagnosis normally requires a combination of techniques.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 5.10 Qualification of test personnel
- 10 Cable testing for long-term operation