Industrial systems, installations and equipment and industrial products – Labelling of cables and cores
Introduction: Additional labelling of cables and cores might be required within larger systems or installations with many cores of the same colour or with many cables, and where therefore the use of the designations provided by the cable manufacturer only would be ambiguous. Due consideration should be given to the fact that additional labelling will cause additional cost, usually increasing with the number of characters in the labelling string and the number of different labelling elements. The available space may also impose restrictions with regard to the number of characters, their height and the length of the labelling. As a general rule the use of additional labelling should therefore be limited to a necessary minimum and be kept as short as practicable. However, also the advantages and benefits should be taken into considerations in choosing additional labelling of cables and cores. It is important to notice that a single machine or a system has different needs of information in the different phases of its lifecycles (assembling, production, service and maintenance). Additional labelling of cables and cores gives the following advantages: the possibilities to communicate and identify signals and connections across different involved engineering disciplines and departments like: process engineering, software engineering, electrical engineering, mechanical/fluid engineering, control engineering; minimizing the time used to locate an eventual error (and the reason for it) in the test p
Scope: This standard provides rules and guidelines for the labelling of cables and cores/conductors used in industrial installations, equipment and products, in order to maintain a clear relation between the technical documentation and the actual equipment and for other purposes. The following methods are described and designated: use of coloured cables and designated cores; additional identification labelling; additional connection labelling; and additional signal labelling. The physical design of the labels, the material to be used for the labels as well as cable manufacturers’ product bound marking of cables and cores are not part of this standard.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Correspondence between labelling and documentation
- 11 Conformance to this standard