IEC 62493-2022 PDF

IEC 62493-2022 PDF

Assessment of lighting equipment related to human exposure to electromagnetic fields

$419.29 $838.57 -50%
Product Code: IEC 62493
Stock In Stock
Edition: 2.1
Published: 06/2022
Number of Pages: 274
File Size: 1 file, 3 Bytes

Available Options

Product Description

Assessment of lighting equipment related to human exposure to electromagnetic fields

Introduction: This International Standard establishes a suitable evaluation method for the influence of the electromagnetic fields in the space around the equipment mentioned in the scope, and defines standardized operating conditions and measurement distances. This standard is designed to assess, by measurements and/or calculations, electromagnetic (EM) fields and their potential effect on the human body by reference to exposure levels of the general public given by ICNIRP:1998 2020 [1]1, ICNIRP 2010 [2], IEEE C95.1:2005 [3] and IEEE C95.6:2002 [4]. The exposure levels with which to comply are basic restrictions (both ICNIRP- and IEEE-based). Based on the lighting equipment operating properties, the frequency range of the applicable basic restrictions can be limited as follows: internal electric field between 20 kHz and 10 MHz; specific absorption rate (SAR) between 100 kHz and 300 MHz; power density is outside the scope. NOTE Operating frequencies of lighting equipment are higher than 20 kHz to avoid audible noise and infrared interference. Frequency contributions above 300 MHz can be neglected. This standard is not meant to supplant definitions and procedures specified in exposure standards, but it is aimed at supplementing the procedure already specified for compliance with exposure. ___________ Numbers in square brackets refer to the Bibliography.

Scope: This International Standard applies to the assessment of lighting equipment related to human exposure to electromagnetic fields. The assessment consists of the induced internal electric field for frequencies from 20 kHz to 10 MHz and the specific absorption rate (SAR) for frequencies from 100 kHz to 300 MHz around lighting equipment. Included in the scope of this standard are: all lighting equipment with a primary function of generating and/or distributing light intended for illumination purposes, and intended either for connection to the low voltage electricity supply or for battery operation; used indoor and/or outdoor; lighting part of multi-function equipment where one of the primary functions of this is illumination; independent auxiliaries exclusively for the use with lighting equipment; lighting equipment including intentional radiators for wireless communication or control. Excluded from the scope of this standard are: lighting equipment for aircraft and airfields; lighting equipment for road vehicles; (except lighting used for the illumination of passenger compartments in public transport) lighting equipment for agriculture; lighting equipment for boats/vessels; photocopiers, slide projectors; apparatus for which the requirements of electromagnetic fields are explicitly formulated in other IEC standards. NOTE The methods described in this standard are not suitable for comparing the fields from different lighting equipment. This standard does not apply to built-in components for luminaires such as electronic controlgear.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62493-2022 PDF

IEC 62493-2022 PDF

$419.29 $838.57