Interface for loudspeakers with digital input signals based on IEC 60958
Introduction: The IEC 60958 interface allows transmission of 2-channel digital audio with up to 24 bit word length at 192 kHz sampling rate. This is adequate for loudspeakers, however, there are additional needs in practice that require standardisation, which go beyond what's currently defined in IEC 60958. This standard is aimed at fulfilling those needs. IEC 60958 features a user bit that can form the basis of a control data channel that addresses those additional requirements. The format of this user bit data channel is based on the existing MIDI standard. Beyond the needs given in IEC 60958, the following offers an exemplary, but incomplete list of of what a digital loudspeaker interface should support: Remote control of operating parameters of the loudspeaker. Remote power-on of the loudspeaker – preferably without requiring standby power in the loudspeaker. Remote configuration of loudspeaker, for example crossover configuration, or firmware update. Remote supervision of loudspeakers, for example chassis temperature or amplifier integrity. Remote identification of loudspeakers, to allow auto-configuration of the entire system. Control of individual or groups of loudspeakers through a single interface. Remote control of Audio System through remote control receiver mounted in loudspeaker enclosure (allowing Audio System to be placed out of sight). Extensions to allow for future applications. NOTE 1 Level and mute control in the loudspeaker is preferred over digital attenuation by the s
Scope: This International Standard specifies the requirements for a digital loudspeaker interface based on the IEC 60958 series of standards and the MIDI specification. It maximizes flexibility and value by combining these previously separate standards. Together, the two standards provide a simple and flexible digital interface for loudspeakers. Examples for applications of the interface can be found in Annex C of this standard.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 6.5.10 Phase right (control number 8, binary, optional)
- 6.5.11 Dimming (control number 9, binary, optional)
- 6.5.12 Indicator (control number 10, binary, optional)
- 6.5.13 High-pass frequency (control number 11, high resolution, optional)
- 6.5.14 High-pass filter in/out (control number 12, binary, optional)
- 6.5.15 Low-pass frequency (control number 13, high resolution, optional)
- 6.5.16 Low-pass filter in/out (control number 14, binary, optional)