Self-ballasted LED-lamps for general lighting services by voltage > 50 V – Safety specifications
Introduction: There will be and are already LED products in the market which substitute existing lamps, either as retrofit mains voltage incandescent or self-ballasted fluorescent lamps or as replacement for tungsten halogen lamps below 50 V. The present document takes up the supply voltage range from > 50 V up to 250 V. A proposal for a safety standard for LED lamps with voltages ≤ 50 V may follow in due time. Future work will also consequently comprise performance standards for all kind of LED lamps, including minimum photometric requirements for type testing. Due to the urgent need of establishing this standard, it will be a stand-alone standard for the time being, not excluding a future relocation as a part of IEC 60968, self-ballasted lamps.
Scope: This International Standard specifies the safety and interchangeability requirements, together with the test methods and conditions required to show compliance of LED-lamps with integrated means for stable operation (self-ballasted LED-lamps), intended for domestic and similar general lighting purposes, having: a rated wattage up to 60 W; a rated voltage of > 50 V up to 250 V; caps according to Table 1. The requirements of this standard relate only to type testing. Recommendations for whole product testing or batch testing are identical to those given in Annex C of IEC 62031. NOTE 1 Where in this standard the term “lamp(s)” is used, it is understood to stand for “self-ballasted LED- lamp(s)”, except where it is obviously assigned to other types of lamps. NOTE 2 This standard includes photobiological safety.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Cap temperature rise
- 11 Resistance to heat
- 12 Resistance to flame and ignition
- 13 Fault conditions
- 13.1 General requirements
- 13.2 Extreme electrical conditions (dimmable lamps) Tests conditions
- 13.3 Extreme electrical conditions (non-dimmable lamps) Compliance
- 13.4 Short-circuit across capacitors
- 13.5 Fault conditions across electronic components
- 13.6 Compliance
- 14 Creepage distances and clearances
- 15 Abnormal operation
- 16 Test conditions for dimmable lamps
- 17 Photobiological safety
- 17.1 UV radiation
- 17.2 Blue light hazard
- 18 Ingress protection
- 18.1 Requirements
- 18.2 Tests
- 19 Information for luminaire design