IEC 62590-3-1-2022 PDF

IEC 62590-3-1-2022 PDF

Railway applications-Fixed installations-Electronic power converters-Part 3-1: AC traction applications-Electronic power compensators

$186.00 $371.99 -50%
Product Code: IEC 62590-3-1
Stock In Stock
Edition: 1.0
Published: 08/2022
Number of Pages: 104
File Size: 1 file, 4 Bytes

Available Options

Product Description

Railway applications – Fixed installations – Electronic power converters – Part 3-1: AC traction applications – Electronic power compensators

Introduction: Single-phase AC traction systems are typically used for railway lines with high power load up to the double-digit MW range. The nature of the loads serving the intended traffic in those railway lines leads to permanent power fluctuations. Due to their inherent structure, single- phase traction systems are prone to having difficulty with power quality indicators such as power factor, voltage fluctuation and/or imbalance within the electric traction system and/or the feeding three-phase power network. In order to improve the power quality, an electronic power compensator can be applied. Components of electronic power compensators especially electronic power converters must withstand the more rugged electric environment when compared with those for other industrial use, due to the nature of electric traction systems mentioned above. This includes not only high load fluctuation, but also frequent switching operation with inrush current and short circuits caused by faults on the overhead contact line systems. Therefore, specific requirements are needed in addition to the common requirements for converters for other industrial use. This document defines typical system configurations and basic requirements as well as appropriate test methods for electronic power compensators used for single-phase AC traction systems. This document is intended for the use by railway operators, manufacturers and system integrators.

Scope: This document specifies the requirements and test methods for electronic power compensators for 1AC traction systems. This equipment is used to improve electric power quality inside the electric traction system and/or at the interface to the 3AC power network, applying power electronics technology. This document applies to equipment which is installed to achieve one or more of the following objectives as its function(s): to mitigate voltage fluctuation; to improve power factor; to reduce imbalance at the interface to the 3AC power network. NOTE In some cases, this type of equipment is used to reduce harmonics from the traction load towards the 3AC power network, and for energy saving. The equipment designed to conform to each particular installation site and the packaged equipment for generic use both fall within the scope of this document. This document applies to equipment with all possible configurations to implement different technical solutions for compensation, but equipment consisting of only passive components is excluded.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62590-3-1-2022 PDF

IEC 62590-3-1-2022 PDF

$186.00 $371.99