IEC 62624-2009 PDF

IEC 62624-2009 PDF

Test methods for measurement of electrical properties of carbon nanotubes

$72.51 $145.02 -50%
Product Code: IEC 62624
Stock In Stock
Edition: 1.0
Published: 08/2009
Number of Pages: 30
File Size: 1 file, 1 Byte

Available Options

Product Description

Test methods for measurement of electrical properties of carbon nanotubes

Scope: This methods for the electrical characterization of carbon nanotubes s . The methods will be independent of processing routes used to fabricate the s. Purpose There is currently no defined standard for the electrical characterization of CNTs and the means of reporting performance and other data. Without openly defined standard test methods, the acceptance and diffusion of technology will be severely impeded. This is intended to provide and suggest procedures for characterization and reporting of data. These methods will enable the creation of a suggested reporting standard that will be used by research through manufacturing as the technology is developed. Moreover, the standards will recommend the necessary tools and procedures for validation. Electrical characterization overview Testing apparatus Testing shall be performed using an electronic device test system with measurement sensitivity sufficient to give a measurement resolution of at least ±0.1% (minimum sensitivity at or better than three orders of magnitude below expected signal level). For example, the smallest current through a CNT can be on the order of 1 pA (10–12 A) or smaller. Therefore, in this case the instrument shall have a resolution of 100 aA (10–16 A) or smaller. Additionally, due to the various impedances encountered in nanoscale measurements, the input impedance of all elements of the test system shall be at least three orders of magnitude greater than the highest impedance in the device. Commercial semiconductor characterization systems with the capability to characterize CNT materials and devices typically have input impedance values of 1013 to 1016 Ω, which is a recommended suitable range. This test method requires that the instrumentation be calibrated against a known and appropriate set of standards [e.g., National Institute of Standards and Technology NIST) . These calibrations may be TEST METHODS FOR MEASUREMENT OF ELECTRICAL PROPERTIES OF CARBON NANOTUBES – 1 – Published by IEC under licence from IEEE. © 2009 IEEE. All rights reserved. IEC 62624:2009(E) IEEE Std 1650-2005(E)

Contents:

  • 1.1 Scope
  • 1.2 Purpose
  • 1.3 Electrical characterization overview
  • 2.1 Definitions
  • 2.2 Acronyms and abbreviations
  • 3.1 Single-walled nanotube
  • 3.2 Multi-walled nanotube
  • 4.1 Materials
  • 4.2 Method for electrode fabrication
  • 4.3 Dimensions
  • 5.1 Architecture design
  • 5.2 Method for processing and fabrication
  • 5.3 Standard characterization procedures
  • 5.4 Environmental control and standards

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62624-2009 PDF

IEC 62624-2009 PDF

$72.51 $145.02