IEC 62631-2-3-2024 PDF

IEC 62631-2-3-2024 PDF

Dielectric and resistive properties of solid insulating materials-Part 2-3: Relative permittivity and dissipation factor-Contact electrode method for insulating films-AC methods

$132.41 $264.81 -50%
Product Code: IEC 62631-2-3
Stock In Stock
Edition: 1.0
Published: 04/2024
Number of Pages: 58
File Size: 0 files

Available Options

Product Description

Dielectric and resistive properties of solid insulating materials – Part 2-3: Relative permittivity and dissipation factor – Contact electrode method for insulating films – AC methods

Introduction: Measuring the relative permittivity and the dielectric dissipation factor (tan δ) of thin insulating polymer films with a thickness of approximately 10 μm to 100 μm without any additional layer is important for insulation applications. There is currently a lack of suitable technology and standard for the measurement of the relative permittivity and dielectric dissipation factor of very thin single-layer polymer films. By using multilayer polymer films with 20 to 50 layers, it can be feasible to get the average value of the relative permittivity and dielectric dissipation factor of an insulating polymer film, but the effect of air gap inside should not be ignored. With metallized electrodes on the surface of the polymer film, it is possible to get acceptable results of the relative permittivity and dielectric dissipation factor of an insulating polymer film in research laboratory. This document provides the measuring technology and the test method for the relative permittivity and dielectric dissipation factor of thin insulating polymer films without any additional layer or metallization on the sample, under technical frequency.

Scope: This part of IEC 62631 specifies the measuring technology and the test method for the relative permittivity and dielectric dissipation factor of thin single layer insulating polymer film without any additional metallization on the sample surface. The adaptive thickness range is approximately 10 μm to 100 μm. The proposed frequency is the power frequency (50 Hz or 60 Hz), and it is also suitable in the technical frequency range from 1 Hz to 1 MHz.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62631-2-3-2024 PDF

IEC 62631-2-3-2024 PDF

$132.41 $264.81