Flexible displays - Part 6-22: Mechanical test methods - Crease and waviness measurement methods for foldable displays
Introduction: The market for foldable display devices is growing rapidly, as shown in the new form factors for portable devices. It is expected that various foldable display devices will be released in the near future. Typically, the cover for rigid displays is made of glass. A rigid glass cover protects the display panel from external shock and produces a surface uniformity without visual distortion. In order to utilize a foldable display, a thin and flexible cover is preferred rather than the thick general rigid cover. Although cover materials like thin films or plastics can be flexible, their surface is rougher and can crease more easily. Based on this expectation, there is an anticipation to standardize the measurement of surface creasing and waviness due to folding in order to evaluate the surface quality of foldable displays. There is a wide variety of ways to analyse the surface of an object, and many of them are already standardized, [1] to [9]1. In this document, two of the non-contact methods and one contact method using a probe are described, and the manner in which to report the values of crease and waviness of foldable displays from the measured data is specified. ___________ 1 Numbers in square brackets refer to the Bibliography.
Scope: This part of IEC 62715 specifies the standard measurement conditions and methods for determining the surface crease and waviness for the evaluation of foldable displays. The measurement methods are used to specify the extent of geometrical distortions in foldable display surfaces. This document applies to foldable display panels and modules. If the foldable display panel has two or more folding axes, this document applies only to the case that folding axes are parallel.
Contents:
- FOREWORD
- INTRODUCTION
- Scope