IEC 62717-2019 PDF

IEC 62717-2019 PDF

LED modules for general lighting - Performance requirements

$447.66 $895.31 -50%
Product Code: IEC 62717
Stock In Stock
Edition: 1.2
Published: 01/2019
Number of Pages: 216
File Size: 1 file, 1 Byte

Available Options

Product Description

LED modules for general lighting - Performance requirements

Introduction: The first edition of a performance standard (precursor: IEC PAS 62717) for LED modules for general lighting applications acknowledges the need for relevant tests for this new source of electrical light, sometimes called “solid state lighting”. The publication is closely related to simultaneously developed performance standard publication (which also started with a Publicly Available Specification) for luminaires in general (IEC 62722-1) and for LED- luminaires (IEC 62722-2-1). Changes in the LED module standard will have an impact on the luminaire standards and vice versa, due to the behaviour of LED. Therefore, in the development of the present standard, a close collaboration between experts of both products has taken place. The provisions in the standard represent the technical knowledge of experts from the fields of the semiconductor (LED chip) industry and of those of the traditional electrical light sources. Three types of LED-modules are covered: with integral controlgear, with means of control on board, but with separate controlgear (“semi-ballasted”), and with complete separate controlgear.

Scope: 1.2 General This International Standard specifies the performance requirements for LED modules, together with the test methods and conditions, required to show compliance with this standard. The following types of LED modules are distinguished and schematically shown in Figure 1: Type 1: integrated LED modules for use on d.c. supplies up to 250 V or on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz. Type 2: LED modules operating with part of separate controlgear connected to the mains voltage, and having further control means inside (“semi-integrated”) for operation under constant voltage, constant current or constant power. Type 3: LED modules where the complete controlgear is separate from the module (non- integrated) for operation under constant voltage, constant current or constant power. The power supply of the controlgear for semi-ballasted LED modules (Type 2) is an electronic device capable of controlling currents, voltage or power within design limits. The control unit of the controlgear for semi-ballasted LED modules (Type 2) is an electronic device to control the electrical energy to the LEDs. A LED module with separate controlgear can be either a non-ballasted LED module or a semi-ballasted LED module. Figure 1 – Types of LED modules The requirements of this standard relate only to type testing. Recommendations for whole product testing or batch testing are under consideration. IEC – 10 – IEC 62717:2014+AMD1:2015 +AMD2:2019 CSV © IEC 2019 This standard covers LED modules, based on inorganic LED technology that produces white light. Life time of LED modules is in most cases much longer than the practical test times. Consequently, verification of manufacturer’s life time claims cannot be made in a sufficiently confident way, because projecting test data further in time is not standardised. For that reason the acceptance or rejection of a manufacturers life time claim, past an operational time as stated in 6.1, is out of the scope of this standard. Instead of life time validation this standard has opted for lumen maintenance codes at a defined finite test time. Therefore, the code number does not imply a prediction of achievable life time. The categories

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62717-2019 PDF

IEC 62717-2019 PDF

$447.66 $895.31