IEC 62878-2-603-2025 PDF

IEC 62878-2-603-2025 PDF

Device embedding assembly technology-Part 2-603: Guideline for stacked electronic module-Test method of intramodule electrical connectivity

$50.44 $100.88 -50%
Product Code: IEC 62878-2-603
Stock In Stock
Edition: 1.0
Published: 02/2025
Number of Pages: 30
File Size: 1 file, 1 Byte

Available Options

Product Description

Device embedding assembly technology – Part 2-603: Guideline for stacked electronic module – Test method of intramodule electrical connectivity

Introduction: High-end servers, network systems, PCs and smart phones have been driving the electronic assembly technologies for the last couple of decades. In order to meet higher demands in computing load from cloud computing and large scale of datacentres with low energy consumption and cost-effective manner, it is important that IoT and edge computing devices achieve greater miniaturization and densification. Stacked electronic module which offers complex and simultaneous integration of various functional modules and specific features is a solution that can meet these demands. The stacked electronic module is produced by means of stacking some stackable electronic modules. The stackable electronic module usually mounts components with area array type package (BGA, LGA, and similar) on the surface and does embed components with wafer-level type package or bare chip into the inner layer to achieve miniaturization and densification. However, from a viewpoint of test and diagnosis the stacked electronic module becomes an invisible, untouchable and undiagnosed structure. Due to its design and construction complexity, it is increasingly critical to test a stacked electronic module with a combination of conventional methods such as external input/output (I/O) terminal or in-circuit test with advanced methods (e.g. boundary scan or bi-directional bus control). This document is one of a series of guidelines for stacked electronic modules.

Scope: This part of IEC 62878 specifies the electrical test method to detect electrical connectivity defects of the stacked electronic module caused by the stacking assembly process to stack some stackable electronic modules. This method is realized to make use of bidirectional serial communication bus interface applied to the stackable electronic modules which are assured as "known good module" (KGM).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62878-2-603-2025 PDF

IEC 62878-2-603-2025 PDF

$50.44 $100.88