IEC 62892-2019 PDF

IEC 62892-2019 PDF

Extended thermal cycling of PV modules-Test procedure

$72.51 $145.02 -50%
Product Code: IEC 62892
Stock In Stock
Edition: 1.0
Published: 04/2019
Number of Pages: 38
File Size: 1 file, 1 Byte

Available Options

Product Description

Extended thermal cycling of PV modules – Test procedure

Introduction: The IEC 61215 series defines test requirements for the design qualification of flat-plate PV modules for long-term operation in general open-air climates. IEC TS 62941 provides technical guidance in application of the type-approval testing. This document, IEC 62892, supplements IEC 61215 by providing an extended thermal cycling test intended to differentiate PV modules with improved durability to thermal cycling and evaluate modules for deployment in locations most susceptible to thermal cycling type stress.

Scope: This document defines a test sequence that extends the thermal cycling test of IEC 61215-2. It is intended to differentiate PV modules with improved durability to thermal cycling and evaluate modules for deployment in locations most susceptible to thermal cycling type stress1. This document is based on the ability for 95 % of the modules represented by the samples submitted for this test to pass an equivalency of 500 thermal cycles, as defined in IEC 61215-2:2016, 4.11.3, with a maximum power degradation of less than 5 %. Provisions are also provided to reduce overall test time by increasing the maximum cycle temperature and/or the number of modules submitted for test. The test procedure in this document was developed based on analysis of the stress on tin-lead solder bonds on crystalline silicon solar cells in a glass superstrate type package. Changes to lead-free solder have an effect on the acceleration factors but not enough to change the overall results of this test. Monolithic type modules with integral cell interconnection do not suffer from this specific type of stress but there are still electrical connections within the module, for example between the integrated cell circuit and the module bus bars, that may be subject to wear out from thermal cycling. Flexible modules (without glass) are not stressed in the same way as those with glass superstrates or substrates, therefore use of the equivalency factor employed in this document may not be applicable to these modules.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62892-2019 PDF

IEC 62892-2019 PDF

$72.51 $145.02