IEC 62899-202-11-2025 PDF

IEC 62899-202-11-2025 PDF

Printed electronics-Part 202-11: Materials-Conductive ink-Measurement method of electrical resistance uniformity for large area printed conductive layer

$50.44 $100.88 -50%
Product Code: IEC 62899-202-11
Stock In Stock
Edition: 1.0
Published: 04/2025
Number of Pages: 18
File Size: 1 file, 1 Byte

Available Options

Product Description

Printed electronics – Part 202-11: Materials – Conductive ink – Measurement method of electrical resistance uniformity for large area printed conductive layer

Introduction: The printing process is used for large area applications such as screen displays or digital signage for an outer wall of a building. It is also used to produce virtually transparent conductive films with uniform conductivity that can replace traditional thin film technologies. For fabrication of large area printed electronics, a conductive layer should be printed uniformly in the whole area. Some defects can occur during the printing process. The most common method to measure the electrical resistivity of printed conductive layer is a four-point probe method which is very useful for obtaining sheet resistance of a conductive layer. However, the measurement area of the four-point probe method is relatively small compared to the whole area of large area devices. Therefore, it is useful to adopt a measurement method that can measure electrical resistance uniformity for a large area device. If the printed layer is very sensitive to the mechanical load of the contact probe, the contactless method (see IEC 62899-202-3) can be applicable. In case of nanomaterials such as carbon nanotube or graphene, in which mechanical damage can occur due to probe contact, the eddy current method can be used (see IEC TS 62607-6-9). This method is limited to the printed conductive layer which does not have mechanical damage during probe contact. In this document, a method to measure the uniformity of resistances of large area printed conductive layers is described. Resistance in a conductive layer i

Scope: This part of IEC 62899 specifies a measurement method of electrical resistance uniformity for large area printed conductive layers. The purpose of this method is to measure resistance uniformity of planar large area printed layers. This method cannot measure sheet resistance. The methods measure electrical resistance or electrical potential drop and use direct contact.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62899-202-11-2025 PDF

IEC 62899-202-11-2025 PDF

$50.44 $100.88