Printed electronics – Part 302-4: Equipment – Inkjet – Medium for inkjet printing dot placement evaluation
Introduction: Until recently, inkjet technologies were used only for imaging printing (conventional “graphic printing”). However, recent developments of inkjet technologies, such as technologies for inkjet print-head, functional ink or print-head driving technologies, make it possible to extend their applications to printed electronics. For these applications, the accuracy requirement for inkjet drop placement tends to be higher than in graphic printing. This document considers that “'inkjet print dot placement accuracy” is the key parameter to obtain an appropriate output that has adequate print quality. In order to evaluate the inkjet printing system, inkjet print dot placement accuracy is measured. For that purpose, an appropriate medium is used, since the “accuracy” of the printed position is only secured by using an appropriate medium that shows actual dot placement. This document describes what kinds of parameters of an appropriate medium are useful to obtain actual accuracy of dot placement evaluation for printed electronics.
Scope: This part of IEC 62899 provides measurement methods and specifications for a medium to measure actual inkjet dot placement for printed electronics applications. NOTE For this document, a medium is a substrate with (a) certain functional layer(s) to facilitate the ink pinning process (or step). These functional layers are either (a) a liquid absorbing layer or (b) a hydrophilic or hydrophobic layer as shown in Figure 1. a) Medium with a liquid absorbing layer b) Medium with a hydrophilic or hydrophobic layer NOTE These figures are examples, and do not show all the required layers of a medium. Figure 1 – Examples of a medium for actual dot placement
Contents:
- FOREWORD
- INTRODUCTION
- Scope