IEC 62899-503-1-2020 PDF

IEC 62899-503-1-2020 PDF

Printed electronics-Part 503-1: Quality assessment-Test method of displacement current measurement for printed thin-film transistor

$50.44 $100.88 -50%
Product Code: IEC 62899-503-1
Stock In Stock
Edition: 1.0
Published: 05/2020
Number of Pages: 20
File Size: 1 file, 1 Byte

Available Options

Product Description

Printed electronics – Part 503-1: Quality assessment – Test method of displacement current measurement for printed thin-film transistor

Introduction: There has been a need for a method to measure and evaluate performance and reliability that is appropriate for printed thin-film transistors (TFTs). In the case of printed TFTs, there is much larger parasitic capacitance than dielectric capacitance in the channel. Accordingly, there has been a need for a method to measure and evaluate the properties for printed TFTs. Carrier behavior is one such property, and mobility and threshold voltage (Vth) for TFTs are other properties. In the case of inorganic TFTs, for example complementary metal-oxide semiconductor (CMOS) TFTs, carriers are induced by the strong inversion at the semiconductor/dielectric interface. But in the case of organic or printed TFTs, carrier generation takes place in the accumulation mode. The total number of carriers in the organic semiconductor layer can often be insufficient to enrich the carrier concentration at the channel. There exists a carrier injection. The carrier injection occurs at the interface of the organic semiconductors' source/drain electrodes. There are three methods to investigate the carrier injection property, that is, Kelvin probe microscopy, four-terminal measurement, and displacement current measurement (DCM). Both Kelvin probe microscopy and four-terminal measurement are indirect methods, but DCM is a direct method to detect charge motion in semiconductors, molecular thin films, and nanoparticles. In this document, the DCM-based channel charge trapping and channel capacitance measurem

Scope: This part of IEC 62899 specifies a test method for displacement current measurement (DCM) for printed thin-film transistors (TFTs) or organic thin-film transistors (OTFTs).

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 62899-503-1-2020 PDF

IEC 62899-503-1-2020 PDF

$50.44 $100.88