Printed electronics – Part 503-3: Quality assessment – Measuring method of contact resistance for the printed thin film transistor – Transfer length method
Introduction: In a thin film transistor (TFT), contact resistance occurs at the contacting interfaces at the gate, source and drain electrodes, and the TFT semiconductor layer. While contact resistance is negligible at the gate electrode, it reduces the effective voltage applied to the source and drain electrodes. Therefore, the evaluation of the contact resistance can provide important insights related to the performance characteristics of printed TFTs. Especially for printed electronics, the contact resistance varies with the employed materials, printing processes and the time series variation because the interface is made of simple contact obtained by additive manufacturing instead of a junction obtained by vacuum deposition and etching processes. Thus, the performance of printed TFTs is greatly influenced by the value of contact resistance. A change of the contact resistance is therefore considered to be a key factor for a proper interpretation of performance, lifetime, and reliability of a printed TFT. To determine the contact resistance, several techniques, including but not limited to two- terminal contact method, four-terminal contact method, six-terminal contact method, transfer length method, and scanning probe potentiometer technique can be used. The transfer length method (TLM) in particular has a practical advantage because the supplier can test discrete devices, which have the same structure as the original printed TFT, on a common substrate simultaneously. Furthermore, the T
Scope: This part of IEC 62899 specifies a measuring method of contact resistance for printed thin film transistors (TFTs) by the transfer length method (TLM). The method requires the fabrication of a test element group (TEG) with varying channel length (L) between source and drain electrodes. The method is intended for quality assessment of TFT electrode contacts and is suited for determining whether the contact resistance lies within a desired range.
Contents:
- FOREWORD
- INTRODUCTION
- Scope