Laser displays - Part 5-8: Measurement of scanning characteristics for raster-scanning laser display
Introduction: A micro-electromechanical system (MEMS) scanner used in raster-scanning laser displays is expected to accurately control the deflection of the laser beam in order to exactly reproduce an image on a projection screen. The scanning characteristics described in this document are affected not only by the accuracy of the beam deflection itself, but also by the precision of the timing control of each image signal in synchronization with the beam trajectories. In practice, deviations are often observed between the projected line patterns on the screen and intended patterns defined by the input image signals [1]1,[2]. Such deviations can result from factors including the inertia of the MEMS scanner, the stability of the laser source, and the performance of the associated driver software. Nevertheless, the projected images can be calibrated by their driver software. Therefore, the measurement of scanning characteristics is essential not only for optimal design of control systems of the MEMS scanner and the laser sources, but also for effective development of the image calibration software. The scanning characteristics in this document include scanning linearity, scanning repeatability, and waviness, as specified in 3.1. Some measurement methods were referenced from Information Display Measurements Standard (IDMS) [3]. ___________ 1 Numbers in square brackets refer to the Bibliography.
Scope: This part of IEC 62906 specifies the standard measurement conditions and methods of scanning characteristics for raster-scanning laser display which uses a MEMS mirror as optical scanner and is designed for projection onto a flat screen.
Contents:
- FOREWORD
- INTRODUCTION
- Scope