Guidelines for the measurement method of power durability for surface acoustic wave (SAW) and bulk acoustic wave (BAW) devices in radio frequency (RF) applications
Introduction: Radio frequency (RF) surface acoustic wave (SAW) and bulk acoustic wave (BAW) devices are now widely used in various communication systems owing to their features such as small size, light weight, little or no need for tuning, high stability and high reliability. One of the most important applications of the devices is the antenna duplexer in mobile communication devices which separates incoming receiving (Rx) signals from base-stations and outgoing transmitting (Tx) signals in the frequency domain. It is known that acoustic vibration can accelerate destruction of electrode metals in the inter-digital transducers (IDTs) employed, which results in device failure. Thus, the device life time (time to failure, TF) is dependent on not only the chip temperature but also on input power level and frequency of the applied radio frequency signal. It should be noted that chip temperature can be somewhat different from the environmental temperature because the input power level of Tx signals in the above-mentioned applications is about 1 W at maximum, and heat generation due to power consumption is not negligible. The requisite TF of the SAW/BAW duplexers is usually specified by input power level, exposure frequency range and environmental temperature. Nevertheless, TF measurement under given specifications is not realistic because the requisite TF is too long (could be up to many years). Accelerated life time testing is applied to shorten the TF. TF is measured in more severe situations
Scope: This document defines the measurement method for the determination of the durability of radio frequency (RF) surface acoustic wave (SAW) and bulk acoustic wave (BAW) devices, such as filters and duplexers, with respect to high power RF signals, which are used in telecommunications, measuring equipment, radar systems and consumer products. RF BAW devices include two types: those based on the film bulk acoustic resonator (FBAR) technology and those based on the solidly mounted resonator (SMR) technology. This document includes basic properties of failure of RF SAW/BAW devices, and guidelines to set up the measurement system and to establish the procedure to estimate the time to failure (TF). Since TF is mainly governed by the RF power applied in the devices, discussions are focused on the power durability. It is not the aim of this document to explain the theory, or to attempt to cover all the eventualities which can arise in practical circumstances. This document draws attention to some of the more fundamental questions which will need to be considered by the user before he/she places an order for an RF SAW/BAW device for a new application. Such a procedure will be the user's means of preventing unsatisfactory performance related to premature device failure resulting from high-power exposure of RF SAW/BAW devices.
Contents:
- FOREWORD
- INTRODUCTION
- Scope