Connectors for electrical and electronic equipment – Part 1: Detail specification for two-way, shielded or unshielded, free and fixed connectors – Mechanical mating information, pin assignment and additional requirements for Type 1 copper LC style
Introduction: The International Electrotechnical Commission (IEC) draws attention to the fact that it is claimed that compliance with this document may involve the use of a patent concerning contact mating surface dimensions given in 5.1. The IEC takes no position concerning the evidence, validity and scope of this patent right. The holder of the patent right on contact mating surface dimensions in 5.1 has assured the IEC that they are willing to give free licences to applicants throughout the world. In this respect, the statement of the holder of this patent right is registered with the IEC Information may be obtained from: CommScope Technologies, LLC 501 Shenandoah Drive Shakopee, Minnesota USA 55379 Attention is drawn to the possibility that some of the elements of this International Standard may be the subject of patent rights other than those identified above. IEC shall not be held responsible for identifying any or all such patent rights. ISO (www.iso.org/patents) and IEC (http://patents.iec.ch) maintain on-line data bases of patents relevant to their standards. Users are encouraged to consult the data bases for the most up to date information concerning patents. IEC 63171 is the base specification of the whole series. Subsequent specifications do not duplicate information given in the base document, but list only additional requirements. For complete specification regarding a component of a higher number document the base numbered documents should be considered as well. The followin
Scope: This part of IEC 63171 covers two-way, shielded or unshielded, free and fixed connectors for data transmission with frequencies up to 600 MHz and with current carrying capacity up to 2,0 A at 60 °C. It is intended to specify the common dimensions, mechanical, electrical, signal integrity, environmental characteristics, reliability specifications and corresponding tests for these connectors.
Contents:
- FOREWORD
- INTRODUCTION
- Scope