Energy efficiency - Customer energy management systems - Part 1: General requirements and architecture
Introduction: In traditional electricity networks, energy flows in one direction and communications from the generator to the consumer is generally done via the transmission and distribution systems. Although there is some monitoring and control of equipment in the transmission and distribution systems, there is no communication with, or control of, consumer equipment. In particular, there is no means of requesting short-term control of consumer equipment to match either the prevailing generation, or transmission and distribution grid conditions, or both. Generation equipment is controlled to match the open-ended (uncontrolled) demand of the consumer. Today the world is faced with an increase of energy consumption, which is directly linked to an increase of CO2 production. The increased CO2 density in the atmosphere supports the climate warming of the earth. One significant way to cope with the increased energy consumption without increasing the CO2 production is to use more renewable energy resources. Unfortunately, the available renewable energy supply is not aligned with the energy demand. To increase efficiency, the energy demand should be aligned as much as possible with the available energy supply. The future grid will become generation led rather than demand led as it is today. In order to reach this goal, communications between the various equipment and systems of the stakeholders within the energy field is necessary. This new form of grid which exchanges information and energy bet
Scope: This part of IEC 63402 specifies general requirements and the architecture between the Point of Common Coupling (PCC) and smart devices (SD) operating within the Smart Grid premises- side system (i.e. residential or commercial but not industrial premises). This document does not include requirements for: safety electromagnetic compatibility (EMC); data security, as it is assumed that the underlying protocols will take the data security aspect into account NOTE Although data security is not within the scope of this document, Clause 4 provides some high-level design guidelines for data security. special equipment (e.g. legacy heat pumps) with a direct physical connection to the grid, as such equipment bypasses the customer energy manager (CEM) and is not HBES/BACS enabled (covered by other standards than the IEC 63402 series). This group EE publication is primarily intended to be used as an EE standard for the products mentioned in the scope, but is also intended to be used by TCs in the preparation of publications for products which are included in the boundary mentioned in the scope of this document.
Contents:
- FOREWORD
- INTRODUCTION
- Scope