Nuclear power plants - Instrumentation and control systems important to safety - Cable connector assemblies for harsh environment purposes
Introduction: a) Technical background, main issues and organisation of the Standard This document focuses on cable assemblies pertaining to components important to safety that are required to function under conditions of design basis accidents and severe accidents. Cable assemblies are to be understood as connectors and cables that are assembled using techniques that ensure the function in case of design basis accidents and severe accidents. Since the opposite part of the connector presents the interface of a component, for instance a sensor, a junction box or an electrical penetration assembly, requirements for the cable connector assembly connector are generally valid for the interface of the connected component. This demand applies at least for counterpart of the connector of the assembly. It is important that cable assemblies used in systems important to safety in nuclear power plants comply with various standards in order to meet their functional safety requirements throughout their qualified life. This goal is accomplished by a thorough design, qualification, manufacturing (assembling), testing, installation and commissioning. Therefore, this IEC document focuses on the above-mentioned aspects to greater extent. Other aspects, relating to quality assurance, reliability and selection including validation and verification activities are not part of this document. This IEC document takes into account: IEC/IEEE 60780-323 on qualification in general, and IEC/IEEE 60980-344 on seismic qual
Scope: This document applies to cable connector assemblies for harsh environment purposes that are important to safety. It covers the engineering safety aspects to be met in the design, qualification, fabrication, assembling, testing, and installation on site of cable connector assemblies to be operated under accident conditions. This document can be additionally used for cable assemblies that are operated under normal conditions. This document covers cable connector assemblies that are used for the following generic functions: signal transmission (AC or DC voltage/current; pulses, frequency), or supplying electrical energy to sensors, transducers, or other devices. Cables in the scope of this document contain polymer materials for sheath and dielectric (polymer cables). Alternatively, cables can consist of metallic sheath and inorganic dielectric (mineral insulated cables). Attached connectors can exhibit a metallic housing and an insulation body made of ceramic or polymer. Gaskets used for the connectors can be made of metal or polymer. Furthermore, cables and connectors in scope of this document are from the multiconductor and coaxial type. Components which are not included in the scope are listed below: instrumentation and control devices that are connected to the assembly, with the exception of the connector interface; terminals; electrical penetration assemblies; field splices for cables; junction boxes in which the cable connector assemblies are installed.
Contents:
- FOREWORD
- INTRODUCTION
- Scope