Guideline for evaluating bias temperature instability of silicon carbide metal-oxide-semiconductor devices for power electronic conversion
Introduction: The objective of this document is to provide useful definitions and procedures for characterizing the threshold voltage instability of SiC-based power electronic conversion semiconductor (PECS) devices having a gate dielectric region biased to turn devices on and off. This typically refers to MOS (Metal-Oxide-Semiconductor) devices such as field-effect transistors (MOSFETs, Metal-Oxide-Semiconductor Field Effect Transistors)) and insulated-gate bipolar transistors (IGBTs). For simplicity reasons, in the following paragraphs the terms MOSFET or MOS device are used only, while the content is valid for IGBT’s as well. Monitoring of threshold-voltage instability in MOS devices is commonly referred to by the term “bias-temperature instability” (BTI), while the applied stress to check for instability is usually referred to as “bias-temperature- stress” (BTS). The terms BTI, BTS, and threshold-voltage instability will be used throughout this document.
Scope: The scope of this document covers SiC-based PECS devices having a gate dielectric region biased to turn devices on and off. This typically refers to MOS devices such as MOSFETs and IGBTs. In this document, only NMOS (N-type MOS) devices are discussed as these are dominant for power device applications; however, the procedures apply to PMOS (P-type MOS) devices as well. This document does not define device failure criteria, acceptable use conditions or acceptable lifetime targets. That is up to the device manufacturers and users. However, it provides stress procedures such that the threshold voltage stability over time as affected by gate bias and temperature can be demonstrated and evaluated.
Contents:
- FOREWORD
- INTRODUCTION
- Scope