Limits and methods of measurement of radio disturbance characteristics of fluorescent lamp and luminaries
Introduction: Subclause 7.5 specifies the operating modes of lighting equipment that must be considered during an emission test. A few examples are given to support the explanation of what ‘different operating modes’ means. The list of examples is of course not exhaustive. Apparently, the example of ‘colour shifting’ is not clear enough and it is sometimes interpreted as if any possible colour and/or correlated colour temperature (CCT) setting that lighting equipment may produce shall be assessed during measurements. Many types of LED lighting may be set in many different colours and CCTs. Compared to other operational-mode related influence quantities such as light level regulation, flashing or radio communication, the risk of not capturing the maximum level of electromagnetic (EM) disturbances due to different colour or CCT settings is very small, provided that all channels of a LED driver used to change colour or CCT are operative. The ‘colour shifting’-example was meant for example for a mode where the light output continuously switches from one colour to another with a certain repetition frequency (e.g. applied for entertainment, events etc.), instead of emitting a single stable colour and/or CCT. CISPR 15:2018-05/ISH1:2019-11(en)
Scope: This document applies to sets out requirements for controlling the emission (radiated and conducted) of radiofrequency disturbances from: lighting equipment (3.3.16) and modules, except for the types excluded in the second paragraph; the lighting part of multi-function equipment where this lighting part is a primary function; NOTE 1 Examples are lighting equipment with visible-light communication, entertainment lighting. UV and IR radiation equipment for residential and non-industrial applications; simple advertising signs (see 3.3.1); NOTE 2 Examples are neon tube advertising signs. decorative and entertainment lighting (see 3.3.6); emergency signs. Excluded from the scope of this document are: components or modules intended to be built into lighting equipment and which are not user-replaceable; NOTE 3 See CISPR 30 (all parts) for built-in controlgear. lighting equipment operating in the ISM frequency bands (as defined in Resolution 63 (1979) of the ITU Radio Regulation); lighting equipment for aircraft and airfield facilities (runways, service facilities, platforms); video signs; lighting equipment intended exclusively for aircraft or airfield facilities (runways, service facilities, platforms). However, general-purpose lighting that can be installed in many locations, including installations not related to aircraft or airfield, is not excluded from the scope of this document; installations; equipment for which the electromagnetic compatibility requirements in the radio-frequency range are explicitly formulated in other CISPR IEC standards, even if they incorporate a built-in lighting function. NOTE 42 Examples of exclusions are: equipment with built-in lighting devices for display back lighting, scale illumination and signalling; SSL-displays; video signs and dynamic displays (in scope of CISPR 32); range hoods, refrigerators, freezers (in scope of CISPR 14); photocopiers, projectors (in scope of CISPR 32); lighting equipment for road vehicles (in scope of CISPR 12); maritime equipment (in scope of IEC TC 18 and TC 80); lighting equipment operating in the ISM frequency bands (in scope of CISPR 11). The frequency range covered is 9 kHz to 400 GHz. No measureme
Contents: