IEC GUIDE 111-1-2023 PDF

IEC GUIDE 111-1-2023 PDF

Electric equipment for high-voltage substations-Common recommendations for product and system standards-Part 1: AC (alternating current)

$163.93 $327.86 -50%
Product Code: IEC GUIDE 111-1
Stock In Stock
Edition: 1.0
Published: 01/2023
Number of Pages: 80
File Size: 1 file, 1.5 MB

Available Options

Product Description

Electric equipment for high-voltage substations – Common recommendations for product and system standards – Part 1: AC (alternating current)

Introduction: This document is for use by IEC technical committees (TCs) involved in high-voltage (HV) substation systems, such as: TC 8, TC 13, TC 14, TC 17, TC 20, TC 22, TC 32, TC 33, TC 36, TC 37, TC 38, TC 57, TC 95, TC 99, TC 115, TC 122, TC 123. It is of paramount importance that the IEC, through this document, ensures consistency and avoids discrepancies between standards within one system. A few discrepancies can be justified in certain cases according to the specificity of a given product or situation. The cost of over-standardization of a component compared to utilization of the nearest linked under-standardized component should be considered. The supplementary cost does not in any way increase the reliability of the system as a whole. Since the same external stresses (climatic, electrical, and mechanical) apply to all the components of the substations, the consistency of their technical features is vital. The same essential requirements for safety, environmental impact, end of life, availability and integration of systems are applicable. All product standards for a single system need to fulfil these requirements with the same degree of responsibility. The aim of this document is to provide common rules for HV substation equipment.

Scope: This part of IEC Guide 111 is a horizontal publication which gives guidance for the harmonization of product and system standards for HV substations (higher than 1 kV). It addresses AC equipment which is found in high-voltage (HV) substations in most cases. This document contains recommendations for common specifications for all HV substation product and system standards, each of which is augmented by the technical background specific to each technical committee, which naturally retains freedom in its technical choices. This document is applicable when developing product and systems standards for HV power electronic equipment for the AC part of the substation. NOTE 1 IEC Guide 111-2 relating to DC (direct current) is under development. Once published, IEC Guide 111-2 will be applicable when developing product and systems standards for the HVDC part of the substation. NOTE 2 The IEC Standardization Management Board (SMB) has decided that Guides such as this one can have mandatory requirements which shall be followed by all IEC committees developing technical work that falls within the scope of the Guide, as well as guidance which may or may not be followed. The mandatory requirements in this Guide are identified by the use of "shall". Statements that are only for guidance are identified by using the verb "should". (See ISO/IEC Directives, IEC Supplement Part 1, A.1.1.)

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC GUIDE 111-1-2023 PDF

IEC GUIDE 111-1-2023 PDF

$163.93 $327.86