Electrical High-Voltage Equipment in High-Voltage Substations - Common Recommendation for Product Standards
Introduction: This Guide is for use by technical committees (TCs) involved in high-voltage (HV) substation systems, such as: TC 13, TC 14, TC 17, TC 20, TC 22, TC 28, TC 32, TC 33, TC 36, TC 37, TC 38, TC 57, TC 95, TC 99. It is of paramount importance that the IEC, through this Guide, finds a way to overcome the lack of consistency and unnecessary discrepancies between standards within one system, even though a few discrepancies might be justified in certain cases according to the specificity of a given product or situation. Furthermore, the cost of over-standardization of one component when the nearest linked component is under-standardized should be considered. The supplementary cost does not in any way increase the reliability of the system as a whole. Since the same external stresses (climatic, electrical, mechanical) apply to all the components of the substations, the consistency of their technical features is vital. Hence, standards will deal more and more with the same essential requirements for safety, environmental impact, end of life, availability and integration of systems. All product standards for a single system have to fulfil these requirements with the same degree of responsibility. The aim of this Guide is to provide common rules for HV substation equipment.
Scope: IEC Guide 111 is a horizontal publication which gives guidance for the harmonization of product and system standards within substations where the highest voltage for equipment is higher than 1 kV. It primarily addresses conventional a.c. equipment which is found in high- voltage (HV) substations in most cases. This Guide contains recommendations for common specifications for all HV substation product standards, each of which is augmented by the technical background specific to each TC, which naturally retains freedom in its technical choices. Where HV power electronic equipment is part of an HV substation, for example, HVDC or SVC, economics and technology dictate a deviation from common clauses as standardized for a.c. equipment. However, when developing product standards for HV power electronic equipment for use in HV substations, the common recommendations of this Guide should be adopted as far as possible. Clearly, any specification in this guide which is inapplicable to a certain type of product, because of that product's inherent characteristics, for example, should not be taken into account when writing standards for that type of product. Reference documents IEC 60027-1, Letter symbols to be used in electrical technology – Part 1: General IEC 60038, IEC standard voltages IEC 60059, IEC standard current ratings IEC 60060-1, High-voltage test techniques – Part 1: General definitions and test requirements IEC 60068 (all parts), Environmental testing IEC 60068-2-18, Environmental testing – Part 2-18: Tests – Test R and guidance: Water IEC 60068-2-75, Environmental testing – Part 2-75: Tests – Test Eh: Hammer tests IEC 60071-1, Insulation co-ordination – Part 1: Definitions, principles and rules IEC 60071-2, Insulation co-ordination – Part 2: Application guide IEC 60216 (all parts), Electric insulating materials – Properties of thermal endurance IEC 60296, Specification for unused mineral insulating oils for transformers and switchgear IEC 60376, Specification and acceptance of new sulphur hexafluoride IEC 60417 (all parts), Graphical symbols for use on equipment Guide 111 IEC:2004(E) – 7 – IEC 60480, Guide to the checking of sulphur hexafluoride (SF6) taken
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 6.10 Rated supply frequency of auxiliary and control circuits
- 7.10 Mechanical stresses on terminals
- 7.11 Interfaces