Nuclear power plants - Instrumentation and control systems important to safety - Software aspects for computer-based systems performing category A functions
Introduction: a) Technical background and main issues Engineering of computer-based instrumentation and control (I&C) systems to be used for nuclear safety purposes is a challenge due to the safety requirements to be fulfilled. The safety software used in nuclear power plants (NPP) which is often required only in emergency cases, is fully validated and qualified before use in operation. In order to achieve the high dependability required, special care is taken throughout the entire lifecycle, including the basic requirements, the various design phases, the verification and validation testing procedures for operation and maintenance. This document addresses the related safety aspects and provides requirements for achieving the high software quality necessary. b) Situation of the current standard in the structure of the SC 45A standard series This document is directly referenced by IEC 61513 which deals with the system aspects of I&C systems and equipment that are used to perform functions important to safety in NPPs. This document is the second level SC 45A document tackling the issue of software aspects for I&C systems performing category A functions. Software for categories B and C functions is dealt with in IEC 62138. This document and IEC 62138 together cover the domain of the software aspects of computer- based systems used in nuclear power plants to perform functions important to safety. IEC 62566 and IEC 62566-2 together cover the domain of the programmable logic used in nuclear powe
Scope: This document provides requirements for the software of computer-based systems of nuclear power plants performing functions of safety category A as defined by IEC 61226. As an IEC/IEEE standard developed according to the Dual Logo Agreement, when used within the context of IEEE, this document is considered to provide an acceptable set of requirements for achieving the quality and dependability objectives for the software used in IEEE Class 1E safety systems, subsystems and components. According to the definition in IEC 61513, I&C systems of safety class 1 are intended to support category A functions, but can also support functions of lower categories. However the system requirements are always determined by the functions of the highest category implemented. For software of I&C system performing only category B and C functions in NPP as defined by IEC 61226, the requirements and guidance of IEC 62138 are applicable. This document provides requirements for the purpose of achieving highly dependable software. It addresses each stage of software generation and documentation, including requirements specification, design, implementation, verification and validation testing. The principles applied in developing these requirements include: best available practices; top-down design methods; modularity; verification of each phase; clear documentation; auditable documents; validation testing. Annex A provides detailed requirements and recommendations for design and implementation of software. Additional informative guidance is given in Annex B to Annex G. This document does not explicitly address the protection of software against threats arising from malicious attacks, that is, cybersecurity, for computer-based systems. IEC 62645 provides cybersecurity requirements. IEC 62671 can be used as an alternative to this document for digital devices of limited functionality. IEC 62671 contains precise criteria to determine if it is applicable to a particular device.
Contents:
- FOREWORD
- INTRODUCTION
- Scope