Bushings for DC application
Introduction: In this first second edition of IEC/IEEE 65700-19-03, service experiences as well as established market requirements have been harmonized with existing IEC and IEEE standards, primarily: IEC 60137, Insulated bushings for alternating voltages above 1 000 V IEC 62199, Bushings for DC application IEEE Std C57.19.00™, IEEE Standard General Requirements and Test Procedures for Outdoor Power Apparatus Bushings Voltage source converter (VSC) technologies have also been included. IEEE Std C57.19.03™, IEEE Standard Requirements, Terminology and Test Code for Bushings for DC Application This dual numbered standard replaces the previous IEC and IEEE DC bushing standards. Where applicable, reference is also made to the following standards: IEC 61462, Composite insulators – Hollow insulators for use in outdoor and indoor electrical equipment; and IEC 62155, Hollow pressurized and unpressurized ceramic and glass insulators for use in electrical equipment with rated voltages greater than 1 000 V. Non-ceramic bushing insulators are widely used in DC applications and this standard applies to similar qualification procedures on all types of insulators, except for the artificial pollution test. Preparation of a bushing for an artificial pollution test destroys the surface of a composite insulator and therefore cannot be performed on such bushings. The range of type tests and routine tests has been carefully planned, considering that high voltage direct current (HVDC) power transmission is a mat
Scope: This International Standard applies to outdoor and indoor bushings of any voltage used on DC systems, of capacitance graded or gas insulated types for use as components of oil liquid-filled converter transformers and smoothing reactors, as well as air-to-air DC bushings. It applies to both line commutated converter (LCC), as well as voltage source converter (VSC) technologies. This document does not apply to the following: cable terminations (potheads); bushings for instrument transformers; bushings for test power supplies; bushings applied with gaseous insulation (other than air at atmospheric pressure) external to the bushing; bushings for industrial application; bushings for traction application; bushings for distribution class transformers. This document refers to IEC 60137 for general terms and conditions and defines the special terms used, operating conditions, ratings, test procedures as well as general mechanical and electrical requirements for bushings for DC application.
Contents:
- FOREWORD
- INTRODUCTION
- Scope