IEC/IEEE/PAS 63547-2011 PDF

IEC/IEEE/PAS 63547-2011 PDF

Interconnecting distributed resources with electric power systems

$163.93 $327.86 -50%
Product Code: IEC/IEEE/PAS 63547
Stock In Stock
Edition: 1.0
Published: 09/2011
Number of Pages: 36
File Size: 1 file, 1000 KB

Available Options

Product Description

Interconnecting distributed resources with electric power systems

Scope: This standard establishes criteria and requirements for interconnection of distributed resources (DR) with electric power systems (EPS). 1.2 Purpose This standard provides a uniform standard for interconnection of distributed resources with electric power systems. It provides requirements relevant to the performance, operation, testing, safety considerations, and maintenance of the interconnection. The requirements shall be met at the point of common coupling (PCC), although the devices used to meet these requirements can be located elsewhere. This standard applies to interconnection based on the aggregate rating of all the DR units that are within the Local EPS. The functions of the interconnection system hardware and software that affect the Area EPS are required to meet this standard regardless of their location on the EPS. The stated specifications and requirements, both technical and testing, are universally needed for interconnection of DR, including synchronous machines, induction machines, or power inverters/converters, and will be sufficient for most installations.1 1.3 Limitations The criteria and requirements in this document are applicable to all distributed resource technologies, [IEC IN SOME COUNTRIES CLAUSE: with aggregate capacity of 10 MVA or less at the PCC], interconnected to EPSs at typical primary and/or secondary distribution voltages. Installation of DR on radial primary and secondary distribution systems is the main emphasis of this standard, although installation of DR on primary and secondary network distribution systems is considered. [IEC IN SOME COUNTRIES CLAUSE: This standard is written considering that the DR is a 60 Hz source]. – This standard does not define the maximum DR capacity for a particular installation that may be interconnected to a single PCC or connected to a given feeder. – This standard does not prescribe DR self-protection or all operating requirements for DR units. – This standard does not address planning, designing, operating, or maintaining the Area EPS. – This standard does not apply to automatic transfer schemes in which load is transferred between the DR and the EPS in a momentary make-before-break _________

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC/IEEE/PAS 63547-2011 PDF

IEC/IEEE/PAS 63547-2011 PDF

$163.93 $327.86