IEC 60034-18-31-2012 PDF

IEC 60034-18-31-2012 PDF

Rotating electrical machines-Part 18-31: Functional evaluation of insulation systems-Test procedures for form-wound windings-Thermal evaluation and classification of insulation systems used in rotating machines

$132.41 $264.81 -50%
Product Code: IEC 60034-18-31
Stock In Stock
Edition: 2.0
Published: 06/2012
Number of Pages: 58
File Size: 1 file, 439 Bytes

Available Options

Product Description

Rotating electrical machines – Part 18-31: Functional evaluation of insulation systems – Test procedures for form-wound windings – Thermal evaluation and classification of insulation systems used in rotating machines

Introduction: IEC 60034-18 comprises several parts, dealing with different types of functional evaluation and special kinds of test procedures for insulation systems of rotating electrial machines. IEC 60034-18-1 provides general guidelines for such procedures and qualification principles. The subsequent parts IEC 60034-18-21, IEC 60034-18-31, IEC 60034-18-32, IEC 60034-18-33, IEC 60034-18-34, IEC 60034-18-41 and IEC 60034-18-42 give detailed procedures for the various types of windings. IEC 60034-18-31 describes thermal evaluation and classification of insulation systems for form-wound windings. It provides standard thermal ageing techniques and diagnostic test procedures. Parts relevant to this document are: IEC 60034-18-1: General guidelines IEC 60034-18-21: Test procedures for wire-wound windings IEC 60034-18-41: Qualification and type tests for Type I electrical insulation systems used in rotating electrical machines fed from voltage converters IEC 60034-18-42: Qualification and acceptance tests for partial discharge resistant electrical insulation systems (Type II) electrical insulation systems used in rotating electrical machines fed from voltage converters

Scope: This part of IEC 60034 describes thermal endurance test procedures for classification of insulation systems used in a.c. or d.c. rotating electrical machines with indirect cooling and form-wound windings. The test performance of a candidate insulation system is compared to the test performance of a reference insulation system with proven service experience. The test procedures described in IEC 60034-18-31 are intended to compare the thermal endurance performance of the mainwall insulation between conductor(s) and ground and, where required by the design of the coil or bar, the insulation between the turns. The test is not intended to simulate the in-service mechanical stresses experienced by the endwinding bracing or support materials. It does not include the evaluation of thermo- mechanical deterioration by expansion and contraction of insulation during temperature cycling. IEC 60034-18-1 describes general testing principles applicable to thermal endurance testing of insulation systems used in rotating electrical machines. The principles of IEC 60034-18-1 are followed unless otherwise stated in IEC60034-18-31. The thermal class for the insulation system refers to its maximum allowed (“hot spot”) temperature. The average temperature measured in service should not exceed the allowed temperature rise according to IEC 60034-1. NOTE 1 Large machines, especially synchronous generators using bars, may require special thermal evaluation test procedures which are not included in this part. NOTE 2 Recommended parameters for the diagnostic test may be applied according to IEC 60034-18-42 to form- wound coils designed with Type II insulation systems for use in converter applications.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60034-18-31-2012 PDF

IEC 60034-18-31-2012 PDF

$132.41 $264.81