IEC 60034-18-42-2020 PDF

IEC 60034-18-42-2020 PDF

Rotating electrical machines-Part 18-42: Partial discharge resistant electrical insulation systems (Type II) used in rotating electrical machines fed from voltage converters-Qualification tests

$343.62 $687.24 -50%
Product Code: IEC 60034-18-42
Stock In Stock
Edition: 1.1
Published: 08/2020
Number of Pages: 200
File Size: 1 file, 3 Bytes

Available Options

Product Description

Rotating electrical machines – Part 18-42: Partial discharge resistant electrical insulation systems (Type II) used in rotating electrical machines fed from voltage converters – Qualification tests

Introduction: The approval of electrical insulation systems for use in rotating electrical machines fed from voltage converters is set out in two International Standards. These standards separate the systems into those which are not expected to experience partial discharge activity within specified conditions in their service lives (Type I) and those which are expected to experience and withstand partial discharge activity in any part of the insulation system throughout their service lives (Type II). For both Type I and Type II insulation systems, the power drive system integrator (the person responsible for co-ordinating the electrical performance of the entire power drive system) shall inform the machine manufacturer what voltage will appear at the machine terminals in service. The machine manufacturer will then decide upon the severity of the tests appropriate for qualifying the insulation system. For insulation systems which have been qualified through IEC 60034-18-41 or IEC 60034-18-42 for use in converter-fed applications, an impulse voltage insulation class may be derived. This indicates the ability of the insulation to withstand the electric stresses resulting from converter operation. For Type I systems, the severity is based on the impulse rise time and the peak to peak voltage. For Type II systems, the severity is additionally affected by the impulse voltage repetition rate and the fundamental voltage characteristics. After installation of the converter/machine system, it is rec

Scope: This part of IEC 60034 defines criteria for assessing the insulation system of stator/rotor windings of single or polyphase AC machines which are subjected to repetitive impulse voltages, such as those generated by pulse width modulation (PWM) converters, and are expected to experience and withstand partial discharge activity during service. It specifies electrical qualification tests on representative specimens to verify fitness for operation with voltage-source converters. It also describes an additional classification system which defines the limits of reliable performance under converter-fed conditions. Although this document deals with voltage converters, it is recognised that there are other types of converters that can create repetitive impulse voltages. For these converters, a similar approach to testing can be used. Qualification of insulation systems may not be required for rotating machines which are only fed from voltage converters for starting and so they are excluded from this document.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60034-18-42-2020 PDF

IEC 60034-18-42-2020 PDF

$343.62 $687.24