IEC 60044-8-2002 PDF

IEC 60044-8-2002 PDF

Instrument transformers - Part 8: Electronic current transformers

$271.12 $542.23 -50%
Product Code: IEC 60044-8
Stock In Stock
Edition: 1.0
Published: 07/2002
Number of Pages: 130
File Size: 1 file, 1 Byte

Available Options

Product Description

Instrument transformers - Part 8: Electronic current transformers

Scope: 1.1 General This part of IEC 60044 applies to newly manufactured electronic current transformers having an analogue voltage output or a digital output, for use with electrical measuring instruments and electrical protective devices at nominal frequencies from 15 Hz to 100 Hz. NOTE Additional requirements due to the bandwidth are considered. The accuracy requirements on harmonics are given in annex D. Clause 12 covers the accuracy requirements that are necessary for electronic current transformers for use with electrical measuring instruments. Clause 13 covers the accuracy requirements that are necessary for electronic current transformers for use with electrical protective relays, and particularly for forms of protection in which the prime requirement is to maintain the accuracy up to several times the rated current. If required, the transient accuracy of an electronic current transformer during fault is also given in this clause. Electronic current transformers intended for both measurement and protection should comply with all the clauses of this standard and are called multipurpose electronic current transformers. The transformer technology can be based on optical arrangements equipped with electrical components, on air-core coils (with or without a built-in integrator), or on iron-core coils with integrated shunt used as a current-to-voltage converter, alone or equipped with electronic components. For analogue output, the electronic current transformer may include the secondary signal cable. Examples of electronic current transformer technologies using air-core coils and iron- core coils with integrated shunt are given in annex C. For digital output, this standard takes into account a point-to-point connection from the electronic transformer to electrical measuring instruments and electrical devices (see annex B). Some information has been added in order to ensure the compatibility of this point-to-point link with the overall system of communication in the substation, thus allowing data exchange between all kinds of substation devices. This information builds what is called the mapping of the link layer of the point-to-point serial link. Processbus communica

Contents:

  • FOREWORD
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60044-8-2002 PDF

IEC 60044-8-2002 PDF

$271.12 $542.23