IEC 60060-3-2006 PDF

IEC 60060-3-2006 PDF

High-Voltage Test Techniques Part 3: Definitions and requirements for on-site testing

$163.93 $327.86 -50%
Product Code: IEC 60060-3
Stock In Stock
Edition: 1.0
Published: 02/2006
Number of Pages: 40
File Size: 1 file, 397 Bytes

Available Options

Product Description

High-Voltage Test Techniques Part 3: Definitions and requirements for on-site testing

Introduction: The requirements specified in IEC 60060-1 and IEC 60060-2 cannot always be achieved during on-site tests, due to a variety of external factors not present in factory and laboratory tests such as external electric and magnetic fields, weather conditions, etc. On-site high-voltage tests are required: as withstand tests as part of a commissioning procedure on equipment to demonstrate that transport from manufacturer to site, and the erection on-site complies with manufacturer’s specification; as withstand tests after on-site repair, to demonstrate that the equipment has been successfully repaired, and is in a suitable condition to return to service; for diagnostic purposes, e.g. PD measurement, to demonstrate if the insulation is still free from dangerous defects, and as an indication of life expectation.

Scope: This part of IEC 60060 is applicable to the following on-site test voltages and in service stresses, which are in relation to IEC 60060-1: direct voltage; alternating voltage; lightning impulse voltage of aperiodic or oscillating shape; switching impulse voltage of aperiodic or oscillating shape. For special tests the following voltages are used: very low frequency voltage; damped alternating voltage. This standard is applicable to equipment with a highest voltage Um greater than 1 kV. The selection of on-site test voltages, test procedures and test voltage levels for apparatus, equipment or installations is under the responsibility of the relevant technical committee. For special applications, on-site test voltages different from those described in this standard may be specified by the relevant technical committee. NOTE 1 The different voltage waveforms listed above do not necessarily provide equal stress on the test object. NOTE 2 The selection of the test voltage levels should take the larger tolerances and measuring uncertainties into account.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60060-3-2006 PDF

IEC 60060-3-2006 PDF

$163.93 $327.86