IEC 60068-2-6-2007 PDF

IEC 60068-2-6-2007 PDF

Environmental testing-Part 2-6: Tests-Test Fc: Vibration (sinusoidal)

$186.00 $371.99 -50%
Product Code: IEC 60068-2-6
Stock In Stock
Edition: 7.0
Published: 12/2007
Number of Pages: 94
File Size: 1 file, 1 Byte

Available Options

Product Description

Environmental testing – Part 2-6: Tests – Test Fc: Vibration (sinusoidal)

Introduction: This part of IEC 60068 gives a method of test applicable to components, equipment and other articles which, during transportation or in service, may be subjected to conditions involving vibration of a harmonic pattern, generated primarily by rotating, pulsating or oscillating forces, such as occur in ships, aircraft, land vehicles, rotorcraft and space applications or are caused by machinery and seismic phenomena. This standard consists basically of subjecting a specimen to sinusoidal vibration over a given frequency range or at discrete frequencies, for a given period of time. A vibration response investigation may be specified which aims at determining critical frequencies of the specimen. The relevant specification shall indicate whether the specimen shall function during vibration or whether it suffices that it still works after having been submitted to vibration. It is emphasized that vibration testing always demands a certain degree of engineering judgement, and both the supplier and purchaser should be fully aware of this fact. However, sinusoidal testing is deterministic and, therefore, relatively simple to perform. Thus it is readily applicable to both diagnostic and service life testing. The main part of this standard deals primarily with the methods of controlling the test at specified points using either analogue or digital techniques, and gives, in detail, the testing procedure. The requirements for the vibration motion, choice of severities including frequency r

Scope: This part of IEC 60068 gives a method of test which provides a standard procedure to determine the ability of components, equipment and other articles, hereinafter referred to as specimens, to withstand specified severities of sinusoidal vibration. If an item is to be tested in an unpackaged form, that is without its packaging, it is referred to as a test specimen. However, if the item is packaged then the item itself is referred to as a product and the item and its packaging together are referred to as a test specimen. The purpose of this test is to determine any mechanical weakness and/or degradation in the specified performance of specimens and to use this information, in conjunction with the relevant specification, to decide upon the acceptability of the specimens. In some cases, the test method may also be used to demonstrate the mechanical robustness of specimens and/or to study their dynamic behaviour. Categorization of components can also be made on the basis of a selection from within the severities quoted in the test.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Recovery
  • 11 Final measurements
  • 12 Information to be given in the relevant specification
  • 13 Information to be given in the test report

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60068-2-6-2007 PDF

IEC 60068-2-6-2007 PDF

$186.00 $371.99