Explosive atmospheres – Part 28: Protection of equipment and transmission systems using optical radiation
Introduction: Optical equipment in the form of lamps, lasers, LEDs, optical fibers etc. is increasingly used for communications, surveying, sensing and measurement. In material processing, optical radiation of high irradiance is used. Often Where the installation is inside or close to potentially explosive atmospheres, and the radiation from such equipment may pass through these atmospheres. Depending on the characteristics of the radiation it might then be able to ignite a surrounding explosive atmosphere. The presence or absence of an additional absorber, such as particles, significantly influences the ignition. There are four possible ignition mechanisms: a) Optical radiation is absorbed by surfaces or particles, causing them to heat up, and under certain circumstances this may allow them to attain a temperature which will ignite a surrounding explosive atmosphere. b) Thermal ignition of a gas volume, where the optical wavelength matches an absorption band of the gas or vapour. c) Photochemical ignition due to photo dissociation of oxygen molecules by radiation in the ultraviolet wavelength range. d) Direct laser induced breakdown of the gas or vapour at the focus of a strong beam, producing plasma and a shock wave both eventually acting as ignition source. These processes can be supported by a solid material close to the breakdown point. The most likely case of ignition occurring in practice with lowest radiation power of ignition capability is case a). Under some conditions for pulsed
Scope: This part of IEC 60079 explains the potential ignition hazard from equipment using optical radiation intended for use in explosive gas atmospheres. It also covers equipment, which itself is located outside but its emitted optical radiation enters such atmospheres. It describes precautions and requirements to be taken when using optical radiation transmitting equipment in explosive gas atmospheres. It also outlines a test method, which can be used to verify a beam is not ignition capable under selected test conditions, if the optical limit values cannot be guaranteed by assessment or beam strength measurement. This part of IEC 60079 specifies the requirements, testing and marking of equipment emitting optical radiation intended for use in explosive atmospheres. It also covers equipment located outside the explosive atmosphere or protected by a Type of Protection listed in IEC 60079-0, but which generates optical radiation that is intended to enter an explosive atmosphere. It covers Groups I, II and III, and EPLs Ga, Gb, Gc, Da, Db, Dc, Ma and Mb. This standard contains requirements for optical radiation in the wavelength range from 380 nm to 10 µm. It covers the following ignition mechanisms: Optical radiation is absorbed by surfaces or particles, causing them to heat up, and under certain circumstances this may allow them to attain a temperature which will ignite a surrounding explosive atmosphere. In rare special cases, direct laser induced breakdown of the gas at the focus of a strong beam, producing plasma and a shock wave both eventually acting as ignition source. These processes can be supported by a solid material close to the breakdown point. NOTE 1 See a) and d) of the introduction. This standard does not cover ignition by ultraviolet radiation and by absorption of the radiation in the explosive mixture itself. Explosive absorbers or absorbers that contain their own oxidizer as well as catalytic absorbers are also outside the scope of this standard. This standard specifies requirements for equipment intended for use under atmospheric conditions. This standard supplements and modifies the general requirements of IEC 60079-0. Where a requirement of this st
Contents:
- FOREWORD
- INTRODUCTION
- Scope