Miniature fuses - Part 7: Miniature fuse-links for special application
Introduction: According to the wish expressed by the users of miniature fuses, all standards, recommendations and other documents relating to miniature fuses should have the same publication number in order to facilitate reference to fuses in other specifications, for example, equipment specifications. Furthermore, a single publication number and subdivision into parts would facilitate the establishment of new standards, because clauses and subclauses containing general requirements need not be repeated. The new IEC 60127 series, under the general heading Miniature fuses, is thus subdivided as follows: IEC 60127, Miniature fuses (general title) IEC 60127-1, Miniature fuses - Part 1: Definitions for miniature fuses and general requirements for miniature fuse-links IEC 60127-2, Miniature fuses - Part 2: Cartridge fuse-links IEC 60127-3, Miniature fuses - Part 3: Sub-miniature fuse-links IEC 60127-4, Miniature fuses - Part 4: Universal modular fuse-links (UMF) - Through-hole and surface mount types IEC 60127-5, Miniature fuses - Part 5: Guidelines for quality assessment of miniature fuse- links IEC 60127-6, Miniature fuses - Part 6: Fuse-holders for miniature fuse-links IEC 60127-7, Miniature fuses - Part 7: Miniature fuse-links for special applications IEC 60127-8, (Free for further documents) Miniature fuses - Part 8: Fuse resistors with particular overcurrent protection IEC 60127-9, (Free for further documents) Miniature fuses - Part 9: Miniature fuse-links for special applications with pa
Scope: This part of IEC 60127 covers requirements for miniature fuse-links for special applications. This part of IEC 60127 is applicable to fuse-links with a rated voltage not exceeding 1 000 V, a rated current not exceeding 20 125 A and a rated breaking capacity not exceeding 50 kA. NOTE Nominal currents above 20 A are intended for protection of low power electric devices at low voltage and not for energy distribution. It does not apply to fuses completely covered by the subsequent parts of IEC 60269-1. It does not apply to miniature fuse-links for appliances intended to be used under special conditions, such as in corrosive or explosive atmospheres. This part of IEC 60127 applies in addition to the requirements of IEC 60127-1:2023. Miniature fuse-links for special applications are not intended to be replaced by the end-user of an electrical / electronic appliance. The object of this part of IEC 60127 is to establish uniform test methods for miniature fuse-links for special applications, so as to allow verification of the values (for example melting time and breaking capacity values) specified by the manufacturer.
Contents:
- FOREWORD
- INTRODUCTION
- Scope