IEC 60191-5-1997 PDF

IEC 60191-5-1997 PDF

Mechanical Standardization of Semiconductor Devices - Part 5: Recommendations Applying to Integrated Circuit Packages Using Tape Automated Bonding (TAB)

$163.93 $327.86 -50%
Product Code: IEC 60191-5
Stock In Stock
Edition: 2.0
Published: 04/1997
Number of Pages: 82
File Size: 1 file, 571 Bytes

Available Options

Product Description

Mechanical Standardization of Semiconductor Devices - Part 5: Recommendations Applying to Integrated Circuit Packages Using Tape Automated Bonding (TAB)

Introduction: The recommendations contained in this standard cover the requirements for tape with bonded integrated circuits (IC) as supplied by a manufacturer to a user. They are not intended to govern strictly internal usage by a company such as the use of TAB as one step in the manufacture of QFP or other packages. Dimensional values or requirements given in this standard for tape width, sprocket holes, test pad patterns, or outer leads, etc. correspond to the state of the technology at the date of publication of this standard. Tape width and sprocket hole dimensions have been derived from motion picture film standards. This standard does not attempt to define the ultimate possibilities of the technology. Progress in integrated circuit assembly technology may lead to inclusion of new or additional recommended dimensions in the future.

Scope: This part of IEC 60191 on mechanical standardization gives recommendations applying to integrated circuits supplied in packages using tape automated bonding (TAB) as the principal component for structural and interconnection functions. This standard is applicable to the finished component supplied by a manufacturer to a user and does not define requirements relating to the IC to tape interface (the inner lead bond or ILB). 2 Terms and definitions For the purpose of this part of IEC 60191, the following definitions apply. 2.1 chip (or die): A portion of a silicon wafer which contains at least one integrated circuit which has been separated from the wafer containing an array of such devices. 2.2 tape carrier1): A linear strip of a laminate of an insulating material and a conducting material patterned so as to mechanically support and electrically contact a chip. The strip may contain a series of such patterns and each such pattern is a tape site. 2.3 sprocket hole: A row of holes on each side of the tape carrier used for driving the tape through equipment or for coarse alignment. 2.4 lead pattern: The pattern of etched conductive material on a tape carrier including the inner and outer leads and the test pads. 2.5 inner lead: The extreme interior end of the lead pattern conductor which is used for connection to a chip. 2.6 device window: A perforation at the centre of a tape site within which the chip and the inner leads are located. 2.7 outer lead or excise window: A rectangular perforation on each side of the tape site over which the conductor pattern is suspended. These perforations may form a continuous opening around the tape site. The bonded circuit is normally excised from the tape by cutting in this opening. 2.8 support ring: The portion of the insulating film which supports the conductor pattern between the device window and the outer lead window. 2.9 body size: The outside dimension of the support ring. ——————— 1) "Tape carrier" may be abbreviated to "tape" when no confusion can arise.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 4.1 Film format
  • 4.2 Alignment holes
  • 4.3 Body size
  • 4.4 Test pad patterns
  • 4.5 Outer lead patterns
  • 4.6 Maximum lead count

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60191-5-1997 PDF

IEC 60191-5-1997 PDF

$163.93 $327.86