Electric cables – Calculation of the current rating – Part 3-2: Sections on operating conditions – Economic optimization of power cable size
Introduction: 0.1 General part The procedure generally used for the selection of a cable size leads to the minimum admissible cross-sectional area, which also minimizes the initial investment cost of the cable. It does not take into account the cost of the losses that will occur during the life of the cable. The increasing financial and environmental cost of energy, together with the energy losses which follow from conductors operating at high temperatures, requires that cable size selection be considered on wider grounds. Rather than minimizing the initial cost only, the sum of the initial cost and the cost of the losses over the anticipated operational life of the system should be minimized. For this latter condition, a larger size of conductor than would be chosen based on minimum initial cost will lead to a lower power loss for the same current. This, when considered over its anticipated operational life, will reduce the energy losses and the total cost of the system. Where thermal consideration dictates the use of the largest practical conductor size, the installation of a second parallel cable circuit can result in a reduction in the total cost over the life of the installation. The formulae and examples given in this standard are arranged to facilitate the calculation of the economic conductor size after factors such as system voltage, cable route, cable configuration and sheath bonding arrangements have been decided. Although these factors are not considered in detail, they have an
Scope: This part of IEC 60287 sets out a method for the selection of a cable size taking into account the initial investments and the future costs of energy losses during the anticipated operational life of the cable. Matters such as maintenance, energy losses in forced cooling systems and time of day energy costs have not been included in this standard. Two examples of the application of the method to hypothetical supply systems are given in Annex A.
Contents:
- FOREWORD
- INTRODUCTION
- Scope