IEC 60287-3-3-2007 PDF

IEC 60287-3-3-2007 PDF

Electric cables-Calculation of the current rating-Part 3-3: Sections on operating conditions-Cables crossing external heat sources

$72.51 $145.02 -50%
Product Code: IEC 60287-3-3
Stock In Stock
Edition: 1.0
Published: 05/2007
Number of Pages: 36
File Size: 1 file, 349 Bytes

Available Options

Product Description

Electric cables – Calculation of the current rating – Part 3-3: Sections on operating conditions – Cables crossing external heat sources

Introduction: In the IEC 60287 series, Part 1 provides general formulae for ratings and power losses of electric cables. Part 2 presents formulae for thermal resistance, with Part 2-1 providing general calculation methods for thermal resistance. Part 2-1 provides calculation methods for dealing with groups of buried cables (see 2.2.3). These methods assume that the cables are laid in parallel and hence every cable acts as a parallel line heat source. This Part 3-3 deals with the crossing of a cable, at right angles or obliquely with another cable, and, more generally, with any linear heat source, such as steam pipes. When heat sources are installed in the vicinity of a cable, the permissible current-carrying capacity of the cable should be reduced to avoid overheating. But applying formulae that are valid for parallel routes would overestimate the thermal influence of the crossing heat source on the cable. In this standard a general simplified method is provided to estimate the reduction of the permissible current-carrying capacity of a cable crossed by heat sources. Every cable and heat source is assumed to be laid horizontally.

Scope: This part of IEC 60287 describes a method for calculating the continuous current rating factor for cables of all voltages where crossings of external heat sources are involved. The method is applicable to any type of cable. The method assumes that the entire region surrounding a cable, or cables, has uniform thermal characteristics and that the principle of superposition applies. The principle of superposition does not strictly apply to touching cables and hence the calculation method set out in this standard will produce an optimistic result if applied to touching cables.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60287-3-3-2007 PDF

IEC 60287-3-3-2007 PDF

$72.51 $145.02