IEC 60317-16-1990 PDF

IEC 60317-16-1990 PDF

Specifications for particular types of winding wires Part 16: Polyester enamelled rectangular copper wire, class 155

$25.22 $50.44 -50%
Product Code: IEC 60317-16
Stock In Stock
Edition: 2.0
Published: 10/1990
Number of Pages: 17
File Size: 1 file, 417 Bytes

Available Options

Product Description

Specifications for particular types of winding wires Part 16: Polyester enamelled rectangular copper wire, class 155

Introduction: This International Standard is one of a series which deals with insulated wires used for windings in electrical equipment. The series has three groups describing: 1) methods of test (IEC 851) ; 2) specifications (IEC 317); 3) packaging (IEC 264).

Scope: This International Standard specifies the requirements of enamelled rectangular copper winding wire of class 155 with a sole coating based on polyester resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. NOTE - A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance certain performance or application characteristics. Class 155 is a thermal class that requires a minimum temperature index of 155 and a heat shock temperature of at least 175 °C. The temperature in degrees Celsius corresponding to the temperature index is not neces- sarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved. The range of nominal conductor dimensions covered by this standard is: - width: min. 2,0 mm max. 16,0 mm; - thickness: min. 0,80 mm max. 5,60 mm. Wires of grade 1 and grade 2 are included in this specification and apply to the complete range of conductors. The specified combinations of width and thickness as well as the specified ratio width/thickness are given in IEC 317-0-2.

Contents:

  • FOREWORD
  • INTRODUCTION
  • 1 Scope
  • 2 Normative references
  • 3 Definitions and general notes on methods of test
  • 4 Dimensions
  • 5 Electrical resistance
  • 6 Elongation
  • 7 Springiness
  • 8 Flexibility and adherence
  • 9 Heat shock
  • 10 Cut-through
  • 11 Resistance to abrasion
  • 12 Resistance to solvents
  • 13 Breakdown voltage
  • 14 Continuity of insulation
  • 15 Temperature index
  • 16 Resistance to refrigerants
  • 17 Solderability
  • 18 Heat or solvent bonding
  • 19 Dielectric dissipation factor
  • 20 Resistance to transformer oil
  • 21 Loss of mass
  • 22 High temperature failure
  • 30 Packaging

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60317-16-1990 PDF

IEC 60317-16-1990 PDF

$25.22 $50.44