IEC 60317-22-2010 PDF

IEC 60317-22-2010 PDF

Specifications for particular types of winding wires-Part 22: Polyester or polyesterimide enamelled round copper wire overcoated with polyamide, class 180

$53.59 $107.18 -50%
Product Code: IEC 60317-22
Stock In Stock
Edition: 3.1
Published: 02/2010
Number of Pages: 22
File Size: 1 file, 1 Byte

Available Options

Product Description

Specifications for particular types of winding wires – Part 22: Polyester or polyesterimide enamelled round copper wire overcoated with polyamide, class 180

Introduction: This part of IEC 60317 is one of a series which deals with insulated wires used for windings in electrical equipment. The series has three groups describing 1) winding wires – Test methods (IEC 60851); 2) specifications for particular types of winding wires (IEC 60317); 3) packaging of winding wires (IEC 60264).

Scope: This part of IEC 60317 specifies the requirements of enamelled round copper winding wire of class 180 with a dual coating. The underlying coating is based on polyester or polyesterimide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. The superimposed coating is based on polyamide resin. NOTE A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance certain performance or application characteristics. Class 180 is a thermal class that requires a minimum temperature index of 180 and a heat shock temperature of at least 200 °C. The temperature in degrees Celsius corresponding to the temperature index is not necessarily that at which it is recommended that the wire be operated and this will depend on many factors, including the type of equipment involved. The range of nominal conductor diameters covered by this standard is as follows: grade 1: 0,050 mm up to and including 3,150 mm; grade 2: 0,050 mm up to and including 5,000 mm; grade 3: 0,250 mm up to and including 1,600 mm. The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-1.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Cut-through
  • 11 Resistance to abrasion (nominal conductor diameters from 0,250 mm up to
  • 12 Resistance to solvents
  • 13 Breakdown voltage
  • 14 Continuity of insulation
  • 15 Temperature index
  • 16 Resistance to refrigerants
  • 17 Solderability
  • 18 Heat or solvent bonding
  • 19 Dielectric dissipation factor
  • 20 Resistance to transformer oil
  • 21 Loss of mass
  • 23 Pin hole test
  • 30 Packaging

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60317-22-2010 PDF

IEC 60317-22-2010 PDF

$53.59 $107.18