IEC 60317-36-2024 PDF

IEC 60317-36-2024 PDF

Specifications for particular types of winding wires-Part 36: Solderable polyesterimide enamelled round copper wire, class 180, with a bonding layer

$107.19 $214.37 -50%
Product Code: IEC 60317-36
Stock In Stock
Edition: 2.2
Published: 06/2024
Number of Pages: 28
File Size: 1 file, 731 Bytes

Available Options

Product Description

Specifications for particular types of winding wires – Part 36: Solderable polyesterimide enamelled round copper wire, class 180, with a bonding layer

Introduction: This part of IEC 60317 is one of a series of standards which deals with insulated wires used for windings in electrical equipment. The series has three groups describing: 1) Winding wires – Test methods (IEC 60851); 2) Specifications for particular types of winding wires (IEC 60317); 3) Packaging of winding wires (IEC 60264).

Scope: This part of IEC 60317 specifies the requirements of solderable enamelled round copper winding wire of class 180 with a dual coating. The underlying coating is based on polyester- imide resin, which may be modified providing it retains the chemical identity of the original resin and meets all specified wire requirements. The superimposed coating is a bonding layer based on a thermoplastic resin. NOTE A modified resin is a resin that has undergone a chemical change, or contains one or more additives to enhance certain performance or application characteristics. The range of nominal conductor diameters covered by this part is: Grade 1B: 0,020 mm up to and including 1,600 mm; Grade 2B: 0,020 mm up to and including 1,600 mm. The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-1:2013.

Contents:

  • FOREWORD
  • INTRODUCTION
  • Scope
  • 10 Cut-through
  • 11 Resistance to abrasion (nominal conductor diameters from 0,250 mm up to and
  • 12 Resistance to solvents
  • 13 Breakdown voltage
  • 14 Continuity of insulation
  • 15 Temperature index
  • 16 Resistance to refrigerants
  • 17 Solderability
  • 17.1 General
  • 17.2 Nominal conductor diameters up to and including 0,100 mm
  • 17.3 Nominal conductor diameters over 0,100 mm
  • 18 Heat or solvent bonding
  • 18.1 Heat bonding
  • 18.1.1 Heat bonding strength of a helical coil
  • 18.1.2 Bond strength on a twisted coil
  • 18.2 Solvent bonding
  • 19 Dielectric dissipation factor
  • 20 Resistance to transformer oil
  • 21 Loss of mass
  • 23 Pin hole test
  • 30 Packaging

Be the first to write a review for this product.

Write a review

Note: HTML is not translated!
Bad           Good
IEC 60317-36-2024 PDF

IEC 60317-36-2024 PDF

$107.19 $214.37