Specifications for particular types of winding wires – Part 60: Polyester glass fibre wound minimum class 155 resin or varnish impregnated or not impregnated, bare or enamelled, rectangular copper wire, temperature index 155
Introduction: This part of IEC 60317 is one of a series which deals with insulated wires used for windings in electrical equipment. The series has three groups describing: 1) Winding wires – Test methods (IEC 60851); 2) Specifications for particular types of winding wires (IEC 60317); 3) Packaging of winding wires (IEC 60264).
Scope: This part of IEC 60317 specifies the requirements of polyester glass fibre wound, impregnated or not impregnated, bare or enamelled rectangular copper winding wire, temperature index 155. NOTE For this type of wire, the heat shock test is inappropriate and therefore a heat shock temperature cannot be established. Consequently, a class based on the requirements for temperature index and heat shock temperature cannot be specified. The range of nominal conductor dimensions covered by this standard is: width: min. 2,0 mm; max. 16,0 mm; thickness: min. 0,80 mm; max. 5,60 mm. The specified combinations of width and thickness as well as the specified width/thickness ratio are according to IEC 60317-0-8.
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 10 Cut-through
- 11 Resistance to abrasion
- 12 Resistance to solvents
- 13 Breakdown voltage
- 14 Continuity of insulation
- 15 Temperature index
- 16 Resistance to refrigerants
- 17 Solderability
- 18 Heat or solvent bonding
- 19 Dielectric dissipation factor
- 20 Resistance to transformer oil
- 23 Pin hole test
- 30 Packaging