Household and similar electrical appliances – Safety – Part 2-108: Particular requirements for electrolysers (Extended Version)
Introduction: Edition 6 of IEC 60335-1:2020 defines and introduces requirements for a detachable power supply part of an appliance. In the document, 24.2 prohibits the use of a power supply in a flexible cord. QUESTION: Does Subclause 24.2 prohibit the use of a detachable power supply part? ANSWER No, a "detachable power supply part" is a defined term and is not captured by the term "power supply" as used in Subclause 24.2. NOTE A detachable power supply part is captured by the defined term when the output of the power supply part is detachable from the class III construction part of the appliance at: the power supply part, or the class III construction part of the appliance. However, the supply cord (if any) does not have to be detachable from the detachable power supply part. IEC 60335-1:2020-09/ISH1:2021-11(en)
Scope: This part of IEC 60335 deals with the safety of electrolysers that produce low viscosity, ionized liquids intended for use as detergent free wash water in appliances for household and similar purposes and which conform with the standards applicable to such appliances. It applies to electrolysers tested separately, under the most severe conditions that can be expected to occur in normal use, their rated voltage being not more than 250 V including direct current (DC) supplied appliances and battery-operated appliances. Examples of appliances that can contain electrolysers are dishwashers (IEC 60335-2-5); washing machines (IEC 60335-2-7); appliances producing wash water for hygiene purposes. This standard does not supersede the requirements of standards relevant to the particular appliance in which the electrolyser is used. However, if the electrolyser used complies with this standard, the tests for the electrolyser specified in the particular appliance standard can be unnecessary in the particular appliance or assembly. If the electrolyser control system is associated with the particular appliance control system, additional tests can be necessary on the final appliance. Guidance for additional requirements to be considered for inclusion in the end product standards for appliances that use electrolysers is given in informative Annex BB. Attention is drawn to the fact that for appliances intended to be used in vehicles or on board ships or aircraft, additional requirements can be necessary; in many countries, additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour, the national water supply authorities and similar authorities. This standard does not apply to appliances intended exclusively for industrial purposes; appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas).
Contents:
- FOREWORD
- INTRODUCTION
- Scope