Household and similar electrical appliances – Safety – Part 2-110: Particular requirements for commercial microwave appliances with insertion or contacting applicators
Introduction: It has been assumed in the drafting of this International Standard that the execution of its provisions is entrusted to appropriately qualified and experienced persons. Guidance documents concerning the application of the safety requirements for appliances can be accessed via TC 61 and SC 61B supporting documents on the IEC website https://www.iec.ch/tc61/supportingdocuments https://www.iec.ch/sc61b/supportingdocuments This information is given for the convenience of users of this International Standard and does not constitute a replacement for the normative text in this standard. This standard recognizes the internationally accepted level of protection against hazards such as electrical, mechanical, thermal, fire and radiation of appliances when operated as in normal use taking into account the manufacturer's instructions. It also covers abnormal situations that can be expected in practice and takes into account the way in which electromagnetic phenomena can affect the safe operation of appliances. This standard takes into account the requirements of IEC 60364 as far as possible so that there is compatibility with the wiring rules when the appliance is connected to the supply mains. However, national wiring rules may can differ. If an appliance within the scope of this standard also incorporates functions that are covered by another part 2 of IEC 60335, the relevant part 2 is applied to each function separately, as far as is reasonable. If applicable, the influence of one fu
Scope: This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of microwave appliances intended for commercial use, their rated voltage being not more than 250 V for single-phase appliances connected between one phase and neutral and 480 V for other appliances. In general, this standard does not take into account persons (including children) whose physical, sensory or mental capabilities; or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction; children playing with the appliance. As far as is practicable, this standard deals with the common hazards presented by these types of appliances. Appliances covered by this standard incorporate an open-ended applicator (as example an overview is given in Figure 103) for treatment of the load. They are divided into three types: with insertion applicator, typically for moisture removal by insertion into holes in floors, walls or ceilings (an example is given in Figure 106); with large area contacting applicator, typically for drying of floors, walls or ceilings (examples are given in Figure 104 and Figure 105); with small area contacting applicator, typically for paint removal and spot-heating (an example is given in Figure 107). Microwave appliances with insertion applicator, large area contacting applicator or small area contacting applicator are using electromagnetic energy in one or several of the ISM frequency bands between 300 MHz and 30 GHz, for supplying energy to an external load which is heated so that a resulting process of drying, moisture transport which can result in forces due to formation of steam, decomposition or chemical modification, melting, or termination of organisms such as bacteria or fungus occurs. NOTE 101 ISM frequency bands are the electromagnetic frequencies established by the ITU and reproduced in CISPR 11. NOTE 102 Food and beverages are not loads in the meaning of this standard. NOTE 101 Appliances with insertion applicator and with large area contacting applicator are portable appliances. Appliances with small area contacting applicator are handheld appliances. NOTE 102 Appliances that use non-el
Contents:
- FOREWORD
- INTRODUCTION
- Scope
- 101 Protection against accessibility to microwave-containing regions